This is probably the problems i have seen.
my usb based card also have a si2168.
since i don't have any good physical machine i used a vm (kvm) and
attached the usb device there.
this works best if the device is in cold state, if driver finds it in
warm state things dont work very well.
but at the moment i also got another issue with the last round of
updates to media_build.
a few weeks ago modueles was loading properly and earlier in the week
when i tested the modules dont load at all and errors during loading.
can test again and post output of dmesg
this is a new issue.
kernel modules from a few weeks ago loads but tuning only works once
after module load.
then there is no signal at all and it doesnt lock on to the signa.
On 2016-02-05 10:40, Rune Petersen wrote:
(sent email again since I managed to reply only to Russel)
I have the same issue - haven't had time to look into it much.
the problem is that si2157 & si2168 doesn't resume properly from suspend.
I have attached 2 patches that disable suspend.
What i have found out:
I can resume the si2157 from suspend by replacing "goto warm" with "goto
skip_fw_download" in si2157_init()
I can 'resume' the si2168 from suspend if I set "dev->fw_loaded = 0" in
si2168_sleep()
Rune
On 04/02/16 20:06, Russel Winder wrote:
On Thu, 2016-02-04 at 18:14 +0200, Antti Palosaari wrote:
[…]
Are you using DVB-T, T2 or C? I quickly tested T and T2 with dvbv5-
zap
and it worked (kernel media 4.5.0-rc1+).
Definitely T and T2. I had been assuming dvbv5-zap switched mode based
on the entry in the virtual channel file. In this case "BBC NEWS" is in
a T multiplex.
PCTV 282e seems to be dibcom based DVB-T only device, so you are
using
DVB-T?
Yes, 282e is T only, ditto Terratec XXS. I haven't been able to get
anything working with WinTVSoloHD or WinTVdualHD as yet.
--
To unsubscribe from this list: send the line "unsubscribe linux-media" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
