On Wed, Dec 25, 2024 at 06:13:34PM +0000, Lothar Rubusch wrote: > Add interrupt-names INT1 and INT2 for the two interrupt lines of the > sensor. > > When one of the two interrupt lines is connected, the interrupt as its > interrupt-name, need to be declared in the devicetree. The driver then > configures the sensor to indicate its events on either INT1 or INT2. > > If no interrupt is configured, then no interrupt-name should be > configured, and vice versa. In this case the sensor runs in FIFO BYPASS > mode. This allows sensor measurements, but none of the sensor events. > > Signed-off-by: Lothar Rubusch <l.rubusch@xxxxxxxxx> Reviewed-by: Krzysztof Kozlowski <krzysztof.kozlowski@xxxxxxxxxx> Best regards, Krzysztof
