On Fri, 27 Dec 2024 08:58:00 +0100 Krzysztof Kozlowski <krzk@xxxxxxxxxx> wrote: > On Wed, Dec 25, 2024 at 06:13:34PM +0000, Lothar Rubusch wrote: > > Add interrupt-names INT1 and INT2 for the two interrupt lines of the > > sensor. > > > > When one of the two interrupt lines is connected, the interrupt as its > > interrupt-name, need to be declared in the devicetree. The driver then > > configures the sensor to indicate its events on either INT1 or INT2. > > > > If no interrupt is configured, then no interrupt-name should be > > configured, and vice versa. In this case the sensor runs in FIFO BYPASS > > mode. This allows sensor measurements, but none of the sensor events. > > > > Signed-off-by: Lothar Rubusch <l.rubusch@xxxxxxxxx> > > Reviewed-by: Krzysztof Kozlowski <krzysztof.kozlowski@xxxxxxxxxx> > > Best regards, > Krzysztof > Applied. thanks Jonathan
