As the pinctrl is now added before the GPIOs are registered we need to manually calculate what the GPIO base will be, otherwise the base for each gpio_range will be set to zero. Fortunately the driver already assigns a GPIO base, in samsung_gpiolib_register, and uses the same calculation it does for the pin_base. Meaning the two will always be the same and allowing us to reuse the pinbase and avoid the issue. Signed-off-by: Charles Keepax <ckeepax@xxxxxxxxxxxxxxxxxxxxxxxxxxx> --- Changes since v1: - Use grange.base in samsung_gpiolib_register to make it more clear the two are related in the driver. Thanks, Charles drivers/pinctrl/samsung/pinctrl-samsung.c | 4 ++-- 1 file changed, 2 insertions(+), 2 deletions(-) diff --git a/drivers/pinctrl/samsung/pinctrl-samsung.c b/drivers/pinctrl/samsung/pinctrl-samsung.c index ddc8d6b..27d5157 100644 --- a/drivers/pinctrl/samsung/pinctrl-samsung.c +++ b/drivers/pinctrl/samsung/pinctrl-samsung.c @@ -882,7 +882,7 @@ static int samsung_pinctrl_register(struct platform_device *pdev, pin_bank->grange.id = bank; pin_bank->grange.pin_base = drvdata->pin_base + pin_bank->pin_base; - pin_bank->grange.base = pin_bank->gpio_chip.base; + pin_bank->grange.base = pin_bank->grange.pin_base; pin_bank->grange.npins = pin_bank->gpio_chip.ngpio; pin_bank->grange.gc = &pin_bank->gpio_chip; pinctrl_add_gpio_range(drvdata->pctl_dev, &pin_bank->grange); @@ -928,7 +928,7 @@ static int samsung_gpiolib_register(struct platform_device *pdev, bank->gpio_chip = samsung_gpiolib_chip; gc = &bank->gpio_chip; - gc->base = drvdata->pin_base + bank->pin_base; + gc->base = bank->grange.base; gc->ngpio = bank->nr_pins; gc->parent = &pdev->dev; gc->of_node = bank->of_node; -- 2.1.4 -- To unsubscribe from this list: send the line "unsubscribe linux-gpio" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html