Hi Marcus,
Marcus Tangermann wrote:
Kernel dying, not just no console?
To be honest I don't know ;-) Maybe it's only an issue with the console.
It should be ttyS0 as this works with 2.6.19-uc1. The snapgear kernel
works when I use the settings for the MonteJade board.
Today I took a look at the sources of the snapgear kernel where the
CONFIG_MARCH_MONTEJADE is used, and there are some modifications within
the 8250 serial driver for this board. I will take a closer look at it
tomorrow.
Over the years there have been some changes to the serial
setup on those boards. Some setups leave out the first
serial port definition, and so what is otherwise considered
ttyS1 will be ttyS0. Something to look out for anyway.
Regards
Greg
------------------------------------------------------------------------
Greg Ungerer -- Chief Software Dude EMAIL: gerg@xxxxxxxxxxxx
Secure Computing Corporation PHONE: +61 7 3435 2888
825 Stanley St, FAX: +61 7 3891 3630
Woolloongabba, QLD, 4102, Australia WEB: http://www.SnapGear.com
--
To unsubscribe from this list: send the line "unsubscribe linux-embedded" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
