Michel Verbraak napsal(a): >> > Pavel, > > The reason why you probably do not get picture on LNB1 is because you > are still getting a stream from LNB0. Probably there is a transponder on > LNB0 with the same frequency and symbolrate as on LNB1 (frequency 11515 > MHz H, symbolrate 27500000) but the specified PIDs (vpid 0x0947, apid > 0x0948) do not exist. Therefore you do not get a picture. > > Have a look at http://nl.kingofsat.net/pos-19.2E.php. Find the > transponder for LNB0 with the same frequency and symbolrate (frequency > 11515 MHz H, symbolrate 27500000) as tried on LNB1 but with a set of > PIDs that exist on LNB0. Change the channels.conf file and szap again to > LNB1 with these parameters. If you do get picture you are sure that the > diseqc switch is not switching but stays on LNB0. > > Please report your result to the list. > > Regards, > > Michel. Hi Michel, I appreciate your help a lot. Fortunately I can tune the second LNB now. I got caught by the scan/mplayer LNB numbering inconsistency too. Regards, Pavel. _______________________________________________ linux-dvb mailing list linux-dvb@xxxxxxxxxxx http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb
