Hi Hartmut, >> I changed the inittab line: >> >> 0x12,0xff,0xa0, // INTP1 POCLKP=1 FEL=1 MFS=0 >> to >> 0x12,0xff,0xa1, // INTP1 POCLKP=1 FEL=1 MFS=0 >> >> but without success. >> > > This configuration is overwritten in budget-av.c. Changing this value in > the init-tab makes no sense. Ok, this is good to know. It might very well explain why I get a lock but data read fails. >> >> PS. Attached is the merged driver diff I've tried to get working. >> > Thanks for using the patch from > http://www.vdr-portal.de/board/attachment.php?attachmentid=13610. Thank you for doing the dirty work. Now if I just could make it to work ... :) >> >> + state->reg0 = tda10023_inittab[0]; // 0x73; // FIXME!!! >> > > I've change this value to the old one from the tda10021 driver. Using of > tda10023_inttab[0] in this way is wrong, because the format of the > inittab has changed. Ok, I'll try to check it out as well. The thing was that with your modifications the driver did not work with Satelco at all, while using the original (ReelBox) values allowed me to get a lock. Do you have more information about the format change ? Regards, Tomi Orava -- _______________________________________________ linux-dvb mailing list linux-dvb@xxxxxxxxxxx http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb
