Hello, I have a Skystar2 Rev 2.3. (http://home.vrweb.de/~bernhardu/skystar2.jpg) A 'lspci -nn' shows me this: 00:07.0 Network controller [0280]: Techsan Electronics Co Ltd Unknown device [13d0:2102] (rev 01) But in flexcop-pci.c is only 13d0:2103 mentioned and mine is 13d0:2102. When I change flexcop-pci.c about line 402 to look like this static struct pci_device_id flexcop_pci_tbl[] = { { PCI_DEVICE(0x13d0, 0x2103) }, { PCI_DEVICE(0x13d0, 0x2102) }, /* { PCI_DEVICE(0x13d0, 0x2200) }, ? */ { }, }; I get following output from dmesg: b2c2-flexcop: B2C2 FlexcopII/II(b)/III digital TV receiver chip loaded successfully flexcop-pci: will use the HW PID filter. flexcop-pci: card revision 1 PCI: Enabling device 0000:00:07.0 (0000 -> 0003) ACPI: PCI Interrupt 0000:00:07.0[A] -> GSI 18 (level, low) -> IRQ 209 DVB: registering new adapter (FlexCop Digital TV device). b2c2-flexcop: reading of MAC address failed. i2c_adapter i2c-4: SMBus Quick command not supported, can't probe for chips b2c2-flexcop: i2c master_xfer failed b2c2-flexcop: i2c master_xfer failed b2c2-flexcop: i2c master_xfer failed mt352_read_register: readreg error (reg=127, ret==-121) b2c2-flexcop: i2c master_xfer failed nxt200x: nxt200x_readbytes: i2c read error (addr 0x0a, err == -121) Unknown/Unsupported NXT chip: 00 00 00 00 00 b2c2-flexcop: i2c master_xfer failed lgdt330x: i2c_read_demod_bytes: addr 0x59 select 0x02 error (ret == -121) b2c2-flexcop: i2c master_xfer failed b2c2-flexcop: i2c master_xfer failed stv0297_readreg: readreg error (reg == 0x80, ret == -121) b2c2-flexcop: i2c master_xfer failed mt312_read: ret == -121 b2c2-flexcop: no frontend driver found for this B2C2/FlexCop adapter ACPI: PCI interrupt for device 0000:00:07.0 disabled Is there any chance to get this card supported? Kind regards Bernhard _______________________________________________ linux-dvb mailing list linux-dvb@xxxxxxxxxxx http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb