Hi. Tom
<snip>
TNT ok
Analogic TV : OK
Capture device : not tested
Remote control : Nothing works (perhaps ...)
Radio : not tested
Radio is Ok
Bye, Bye
Well, that's all for today !
Good luck
Hartmut
Thanks :)
Tom
So you have the board fully working now?
I am in doubt about this:
+ case SAA7134_BOARD_HAUPPAUGE_HVR1110:
+ ir_codes = ir_codes_hauppauge_new;
+// ir_type = IR_TYPE_RC5;
+ mask_keycode = 0;
+ polling = 50; // ms
+ break;
if mask_keycode applies to the complete GPIO port (not sure
in this case), this cannot be right since part of this
port is used for the DVB transport stream. Can you please
cross check this?
Also i must say that i lost sync. After you checked, can you
please resend your patch (maybe to me personally) so that i can
integrate it?
Hartmut
_______________________________________________
linux-dvb mailing list
linux-dvb@xxxxxxxxxxx
http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb
