Hi Hartmut,
Hartmut Hackmann wrote:
Hi, all
Mark Callaghan wrote:
James, Hartmut,
I have also had "interesting" PCI ID behaviour from my Compro
VideoMate, on
FC4.
I have seen the correct PCI ID in dmesg, but I usually get 1850:0000
(or was
it 185b:0000?). I can't remember the exact ID. I've been using a
modprobe.conf workaround to get the saa7134-dvb module loaded.
My suspicion was that it was related to whether the machine was reset or
went through a power-down.
That makes sense! Can you please verify this?
I suspect that the board allows to remap the address of the eeprom that
defines the ID. This might be done i.e. with GPIOs of the SAA7134.
<snip>
I can verify it - see my previous post. Tonight I'll post the full
report from dmesg under the two circumstances: after a power down and
after a non-powerdown reset.
Could the problem I have seen with the remote control be related? I was
wondering whether both problems were somehow related to buffering
problems in the i2c.
Regards,
James.
_______________________________________________
linux-dvb@xxxxxxxxxxx
http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb
