Hi Hartmut,
I started again from the top with yet another clean install of
gentoo. This time the kernel version was 2.6.15r7.
This time, when I modprobe saa7134 the card is recognized correctly
with PCI ID of 185b:c900, with NO CODE MODs.
I have not yet tested to see if the cards actually work - I will post
another reply only if they do not.
I have not yet checked the remote control issue as I have not yet got
that far. I will post a reply to that message when I have tested it.
I recommend that you do not make the patch I previously suggested as
both my cards are now correctly recognized. There is obviously
something else weird going on that I don't understand ... it is very
odd that I should see the same erroneous behavior for OSS SuSE 10.0
64 bit and for Gentoo compiled for AMD64, then have it behave
correctly when I reinstall Gentoo, still targeted at AMD64.
Regards,
James.
On 14/03/2006, at 9:56 AM, Hartmut Hackmann wrote:
Hi, James
James Lawrence wrote:
Hi,
I have two Compro VideoMate DVB-T300 cards installed in my
computer. The saa7134 drivers do not recognize them correctly. I
have had to make code modifications to get the drivers to
recognize them, as shown below. Has anyone else experienced this?
If you look closely, you will see that the PCI ID of both cards is
identical: 1850:0000. This is odd - Compro's subvendor ID is 185B
not 1850 and 0000 is a strange subdevice ID.
My computer configuration is:
AMD64 CPU
Gigabyte GA-K8NSC-939 motherboard with NFORCE3 chipset
Gentoo Linux with 2.6.15r5 kernel
- I got the same result previously when trying with 64 bit SuSE
OSS 10.0 with a 2.6.13 kernel and drivers compiled from the v4l-
dvb repository.
<snip>
Funny that nobody replied...
I put your patch to my personal repository and will ask Mauro to
pull soon.
I can't do much on the remote control issue - due to lack of hardware.
Best regards
Hartmut
_______________________________________________
linux-dvb@xxxxxxxxxxx
http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb
