Philip Prindeville wrote: > Manu Abraham wrote: > >> Philip Prindeville wrote: >> >>> >>> Here's my logs, but as I said, I had to run the "modprobe bttv0" by >>> hand... >>> >>> Oct 29 18:17:47 tuner kernel: IrDA: Registered device irda0 (via-ircc) >>> Oct 29 18:17:47 tuner kernel: Linux video capture interface: v1.00 >>> Oct 29 18:17:47 tuner kernel: cx2388x dvb driver version 0.0.4 loaded >>> Oct 29 18:17:47 tuner kernel: cx88[0]: subsystem: 7063:3000, board: >>> pcHDTV HD3000 HDTV [card=22,autodetected] >>> Oct 29 18:17:47 tuner kernel: ACPI: PCI Interrupt Link [LNKB] >>> enabled at IRQ 12 >>> Oct 29 18:17:47 tuner kernel: PCI: setting IRQ 12 as level-triggered >>> Oct 29 18:17:47 tuner kernel: ACPI: PCI Interrupt 0000:00:14.2[A] -> >>> Link [LNKB] -> GSI 12 (level, low) -> IRQ 12 >>> Oct 29 18:17:47 tuner kernel: cx88[0]/2: found at 0000:00:14.2, rev: >>> 5, irq: 12, latency: 32, mmio: 0xdf000000 >>> Oct 29 18:17:47 tuner kernel: cx88[0]/2: cx2388x based dvb card >> >> >> >> >> You have the frontend for the cx88 .. >> >>> Oct 29 18:17:47 tuner kernel: DVB: registering new adapter (cx88[0]). >>> Oct 29 18:17:47 tuner kernel: DVB: registering frontend 0 (pcHDTV >>> HD3000 HDTV)... >>> Oct 29 18:17:47 tuner kernel: cx2388x v4l2 driver version 0.0.4 loaded >>> Oct 29 18:17:47 tuner kernel: ACPI: PCI Interrupt 0000:00:14.0[A] -> >>> Link [LNKB] -> GSI 12 (level, low) -> IRQ 12 >>> Oct 29 18:17:47 tuner kernel: cx88[0]/0: found at 0000:00:14.0, rev: >>> 5, irq: 12, latency: 32, mmio: 0xde000000 >>> Oct 29 18:17:47 tuner kernel: tuner 0-0061: chip found @ 0xc2 (cx88[0]) >>> Oct 29 18:17:47 tuner kernel: tuner 0-0061: type set to 52 (Thomson >>> DDT 7610 (ATSC/NTSC)) >>> Oct 29 18:17:47 tuner kernel: cx88[0]/0: registered device video0 >>> [v4l2] >>> Oct 29 18:17:47 tuner kernel: cx88[0]/0: registered device vbi0 >>> Oct 29 18:17:47 tuner kernel: cx88[0]/0: registered device radio0 >>> Oct 29 18:17:47 tuner kernel: bttv: driver version 0.9.15 loaded >>> Oct 29 18:17:47 tuner kernel: bttv: using 8 buffers with 2080k (520 >>> pages) each for capture >>> Oct 29 18:17:47 tuner kernel: bttv: Bt8xx card found (0). >>> Oct 29 18:17:47 tuner kernel: ACPI: PCI Interrupt 0000:00:13.0[A] -> >>> Link [LNKA] -> GSI 10 (level, low) -> IRQ 10 >>> Oct 29 18:17:47 tuner kernel: bttv0: Bt878 (rev 17) at 0000:00:13.0, >>> irq: 10, latency: 32, mmio: 0xe0001000 >>> Oct 29 18:17:47 tuner kernel: bttv0: detected: ChainTech digitop >>> DST-1000 DVB-S [card=113], PCI subsystem ID is 270f:fc00 >>> Oct 29 18:17:47 tuner kernel: bttv0: using: Twinhan DST + clones >>> [card=113,autodetected] >>> Oct 29 18:17:47 tuner kernel: bttv0: using tuner=4 >>> Oct 29 18:17:47 tuner kernel: bttv0: add subdevice "dvb0" >>> Oct 29 18:17:47 tuner kernel: bt878: no version for "struct_module" >>> found: kernel tainted. >>> Oct 29 18:17:47 tuner kernel: bt878: AUDIO driver version 0.0.0 loaded >>> Oct 29 18:17:47 tuner kernel: bt878: Bt878 AUDIO function found (0). >>> Oct 29 18:17:47 tuner kernel: ACPI: PCI Interrupt 0000:00:13.1[A] -> >>> Link [LNKA] -> GSI 10 (level, low) -> IRQ 10 >>> Oct 29 18:17:47 tuner kernel: bt878(0): Bt878 (rev 17) at 00:13.1, >>> irq: 10, latency: 32, memory: 0xe0002000 >>> Oct 29 18:17:47 tuner kernel: ACPI: PCI Interrupt Link [LNKD] >>> enabled at IRQ 7 >>> Oct 29 18:17:47 tuner kernel: PCI: setting IRQ 7 as level-triggered >>> Oct 29 18:17:47 tuner kernel: ACPI: PCI Interrupt 0000:00:10.3[D] -> >>> Link [LNKD] -> GSI 7 (level, low) -> IRQ 7 >>> ... >>> Oct 29 19:20:29 tuner kernel: or51132: Waiting for firmware >>> upload(dvb-fe-or51132-vsb.fw)... >>> Oct 29 19:20:39 tuner kernel: or51132: Version: 10001134-19430000 >>> (113-4-194-3) >>> Oct 29 19:20:39 tuner kernel: or51132: Firmware upload complete. >>> Oct 29 19:21:17 tuner kernel: DVB: registering new adapter (bttv0). >>> Oct 29 19:21:17 tuner kernel: dst_get_device_id: Recognise [DST-03T] >>> Oct 29 19:21:17 tuner kernel: DST type : satellite >>> Oct 29 19:21:17 tuner kernel: DST type flags : 0x2 ts204 0x4 symdiv >>> 0x10 firmware version = 2 >>> Oct 29 19:21:17 tuner kernel: DVB: registering frontend 1 (DST >>> DVB-S)... >>> >> >> You have the dst too .. >> >>> >>> Any more suggestions? >>> >> >> Now what's the problem.. ? >> >> Manu >> > > Well, it's not installing "dst" on reboot. I have to do "modprobe > bttv0" and "modprobe bttv1" > by hand... I am not very clear on the install and --ignore-install-options. If you don't find any help on this, maybe you can try out on the Fedora lists. https://www.redhat.com/archives/fedora-list/ https://www.redhat.com/archives/fedora-config-list/ If you find a solution, please do update the documentation on the wiki as well .. Manu Manu
