Philip Prindeville wrote: > > Here's my logs, but as I said, I had to run the "modprobe bttv0" by > hand... > > Oct 29 18:17:47 tuner kernel: IrDA: Registered device irda0 (via-ircc) > Oct 29 18:17:47 tuner kernel: Linux video capture interface: v1.00 > Oct 29 18:17:47 tuner kernel: cx2388x dvb driver version 0.0.4 loaded > Oct 29 18:17:47 tuner kernel: cx88[0]: subsystem: 7063:3000, board: > pcHDTV HD3000 HDTV [card=22,autodetected] > Oct 29 18:17:47 tuner kernel: ACPI: PCI Interrupt Link [LNKB] enabled > at IRQ 12 > Oct 29 18:17:47 tuner kernel: PCI: setting IRQ 12 as level-triggered > Oct 29 18:17:47 tuner kernel: ACPI: PCI Interrupt 0000:00:14.2[A] -> > Link [LNKB] -> GSI 12 (level, low) -> IRQ 12 > Oct 29 18:17:47 tuner kernel: cx88[0]/2: found at 0000:00:14.2, rev: > 5, irq: 12, latency: 32, mmio: 0xdf000000 > Oct 29 18:17:47 tuner kernel: cx88[0]/2: cx2388x based dvb card You have the frontend for the cx88 .. > Oct 29 18:17:47 tuner kernel: DVB: registering new adapter (cx88[0]). > Oct 29 18:17:47 tuner kernel: DVB: registering frontend 0 (pcHDTV > HD3000 HDTV)... > Oct 29 18:17:47 tuner kernel: cx2388x v4l2 driver version 0.0.4 loaded > Oct 29 18:17:47 tuner kernel: ACPI: PCI Interrupt 0000:00:14.0[A] -> > Link [LNKB] -> GSI 12 (level, low) -> IRQ 12 > Oct 29 18:17:47 tuner kernel: cx88[0]/0: found at 0000:00:14.0, rev: > 5, irq: 12, latency: 32, mmio: 0xde000000 > Oct 29 18:17:47 tuner kernel: tuner 0-0061: chip found @ 0xc2 (cx88[0]) > Oct 29 18:17:47 tuner kernel: tuner 0-0061: type set to 52 (Thomson > DDT 7610 (ATSC/NTSC)) > Oct 29 18:17:47 tuner kernel: cx88[0]/0: registered device video0 [v4l2] > Oct 29 18:17:47 tuner kernel: cx88[0]/0: registered device vbi0 > Oct 29 18:17:47 tuner kernel: cx88[0]/0: registered device radio0 > Oct 29 18:17:47 tuner kernel: bttv: driver version 0.9.15 loaded > Oct 29 18:17:47 tuner kernel: bttv: using 8 buffers with 2080k (520 > pages) each for capture > Oct 29 18:17:47 tuner kernel: bttv: Bt8xx card found (0). > Oct 29 18:17:47 tuner kernel: ACPI: PCI Interrupt 0000:00:13.0[A] -> > Link [LNKA] -> GSI 10 (level, low) -> IRQ 10 > Oct 29 18:17:47 tuner kernel: bttv0: Bt878 (rev 17) at 0000:00:13.0, > irq: 10, latency: 32, mmio: 0xe0001000 > Oct 29 18:17:47 tuner kernel: bttv0: detected: ChainTech digitop > DST-1000 DVB-S [card=113], PCI subsystem ID is 270f:fc00 > Oct 29 18:17:47 tuner kernel: bttv0: using: Twinhan DST + clones > [card=113,autodetected] > Oct 29 18:17:47 tuner kernel: bttv0: using tuner=4 > Oct 29 18:17:47 tuner kernel: bttv0: add subdevice "dvb0" > Oct 29 18:17:47 tuner kernel: bt878: no version for "struct_module" > found: kernel tainted. > Oct 29 18:17:47 tuner kernel: bt878: AUDIO driver version 0.0.0 loaded > Oct 29 18:17:47 tuner kernel: bt878: Bt878 AUDIO function found (0). > Oct 29 18:17:47 tuner kernel: ACPI: PCI Interrupt 0000:00:13.1[A] -> > Link [LNKA] -> GSI 10 (level, low) -> IRQ 10 > Oct 29 18:17:47 tuner kernel: bt878(0): Bt878 (rev 17) at 00:13.1, > irq: 10, latency: 32, memory: 0xe0002000 > Oct 29 18:17:47 tuner kernel: ACPI: PCI Interrupt Link [LNKD] enabled > at IRQ 7 > Oct 29 18:17:47 tuner kernel: PCI: setting IRQ 7 as level-triggered > Oct 29 18:17:47 tuner kernel: ACPI: PCI Interrupt 0000:00:10.3[D] -> > Link [LNKD] -> GSI 7 (level, low) -> IRQ 7 > ... > Oct 29 19:20:29 tuner kernel: or51132: Waiting for firmware > upload(dvb-fe-or51132-vsb.fw)... > Oct 29 19:20:39 tuner kernel: or51132: Version: 10001134-19430000 > (113-4-194-3) > Oct 29 19:20:39 tuner kernel: or51132: Firmware upload complete. > Oct 29 19:21:17 tuner kernel: DVB: registering new adapter (bttv0). > Oct 29 19:21:17 tuner kernel: dst_get_device_id: Recognise [DST-03T] > Oct 29 19:21:17 tuner kernel: DST type : satellite > Oct 29 19:21:17 tuner kernel: DST type flags : 0x2 ts204 0x4 symdiv > 0x10 firmware version = 2 > Oct 29 19:21:17 tuner kernel: DVB: registering frontend 1 (DST DVB-S)... > You have the dst too .. > > Any more suggestions? > Now what's the problem.. ? Manu
