Add support for wlan-2g LED on GPIO 64. Signed-off-by: Sridharan S N <quic_sridsn@xxxxxxxxxxx> --- Changes in V4: - Added patch dependency. This change depends on below patch set https://lore.kernel.org/linux-arm-msm/20230614085040.22071-2-quic_anusha@xxxxxxxxxxx/ Changes in V3: - Updated patch series title. Mentioned platform in series title Changes in V2: - No changes .../boot/dts/qcom/ipq9574-rdp-common.dtsi | 20 +++++++++++++++++++ 1 file changed, 20 insertions(+) diff --git a/arch/arm64/boot/dts/qcom/ipq9574-rdp-common.dtsi b/arch/arm64/boot/dts/qcom/ipq9574-rdp-common.dtsi index fd5326dc1773..25424cecd834 100644 --- a/arch/arm64/boot/dts/qcom/ipq9574-rdp-common.dtsi +++ b/arch/arm64/boot/dts/qcom/ipq9574-rdp-common.dtsi @@ -34,6 +34,18 @@ debounce-interval = <60>; }; }; + + leds { + compatible = "gpio-leds"; + pinctrl-0 = <&gpio_leds_default>; + pinctrl-names = "default"; + + led-0 { + gpios = <&tlmm 64 GPIO_ACTIVE_LOW>; + linux,default-trigger = "phy0tx"; + default-state = "off"; + }; + }; }; &blsp1_spi0 { @@ -137,6 +149,14 @@ drive-strength = <8>; bias-pull-up; }; + + gpio_leds_default: gpio-leds-default-state { + pins = "gpio64"; + function = "gpio"; + drive-strength = <8>; + bias-pull-up; + }; + }; &xo_board_clk { -- 2.17.1
