Ahmed, I apologize for not knowing about PRI as to know how to help you. I am forwarding your message to list Linmodems discuss@xxxxxxxxxxxxx as some other folks might know more and be able to help you. Regards, Antonio On 5/19/11, Ahmed Munir <ahmedmunir007@xxxxxxxxx> wrote: > Hi, > > Need to know, which parameters or commands required for configuring an ISDN > PRI? Where I'm trying to use PRI single channel as modem one. My commands > are listed down below and as I try to run an application I'm getting a > message "No Carrier". The application I'm using is Qpage for paging > messages. > > modem=ttya > device=/dev/ttySL1 > initcmd=ATZ=E1Q0+FCLASS=0 > service=abc > device=ttya > baudrate=9600 > parity=none > maxtries=3 > maxmsgsize=255 > maxpages=9 > allowpid=true > phone=14089612819 > > The way I'm using slmodem is that I'm binding softmodem with each PRI > channel as listed below; > slmodemd -c=USA /dev/dahdi/1 > > In return it creates a softlink i.e. /dev/ttySL1. Further added, my above > configuration is working fine on us robotics usbmodem. > > > Please assist me in this problem, I'm stuck in this problem for many days. > > -- > Regards, > > Ahmed Munir >
