Hi Marv, after removed sl-modem-sources and daemon without shutdown pc I made: ciornj@deskubu904:~$ sudo apt-get install sl-modem-source [sudo] password for ciornj: Lettura della lista dei pacchetti in corso... Fatto Generazione dell'albero delle dipendenze in corso Lettura informazioni sullo stato... Fatto I seguenti pacchetti NUOVI (NEW) saranno installati: sl-modem-source 0 aggiornati, 1 installati, 0 da rimuovere e 0 non aggiornati. È necessario prendere 0B/498kB di archivi. Dopo quest'operazione, verranno occupati 1167kB di spazio su disco. Selezionato il pacchetto sl-modem-source, che non lo era. (Lettura del database ... 200955 file e directory attualmente installati.) Spacchetto sl-modem-source (da .../sl-modem-source_2.9.11~20080817-3ubuntu2_i386.deb) ... Configuro sl-modem-source (2.9.11~20080817-3ubuntu2) ... Adding Module to DKMS build system Doing initial module build Installing initial module Done.ciornj@deskubu904:~$ sudo slmodemd -c ITALY /dev/slamr0 error: mdm setup: cannot stat `/dev/slamr0': No such file or directory error: cannot setup device `/dev/slamr0' ciornj@deskubu904:~$ dmesg | tail -15 [ 21.617661] Bluetooth: BNEP (Ethernet Emulation) ver 1.3 [ 21.617667] Bluetooth: BNEP filters: protocol multicast [ 21.640490] Bridge firewalling registered [ 26.839640] skge eth0: enabling interface [ 26.843100] ADDRCONF(NETDEV_UP): eth0: link is not ready [ 29.847902] skge eth0: Link is up at 100 Mbps, full duplex, flow control both [ 29.848117] ADDRCONF(NETDEV_CHANGE): eth0: link becomes ready [ 40.104010] eth0: no IPv6 routers present [ 170.722312] device 10b9:5459 is grabbed by driver serial: try to release [ 170.724172] serial 0000:02:02.0: PCI INT A disabled [ 223.714548] slamr: SmartLink AMRMO modem. [ 223.714644] slamr: probe 10b9:5459 SL1800 card... [ 223.714662] slamr 0000:02:02.0: PCI INT A -> GSI 22 (level, low) -> IRQ 22 [ 223.716822] slamr: mc97 codec is SIL26 [ 223.717071] slamr: slamr0 is SL1800 card. ciornj@deskubu904:~$ ciornj@deskubu904:~$ sudo apt-get install sl-modem-daemon Lettura della lista dei pacchetti in corso... Fatto Generazione dell'albero delle dipendenze in corso Lettura informazioni sullo stato... Fatto I seguenti pacchetti NUOVI (NEW) saranno installati: sl-modem-daemon 0 aggiornati, 1 installati, 0 da rimuovere e 0 non aggiornati. È necessario prendere 0B/514kB di archivi. Dopo quest'operazione, verranno occupati 1147kB di spazio su disco. Preconfigurazione dei pacchetti in corso Selezionato il pacchetto sl-modem-daemon, che non lo era. (Lettura del database ... 200996 file e directory attualmente installati.) Spacchetto sl-modem-daemon (da .../sl-modem-daemon_2.9.11~20080817-3ubuntu2_i386.deb) ... Processing triggers for man-db ... Configuro sl-modem-daemon (2.9.11~20080817-3ubuntu2) ... Attenzione: impossibile accedere alla directory home /var/log/slmodemd indicata: Nessun file o directory L'utente di sistema «Slmodemd» già esiste. Uscita. usermod: nessuna modifica Starting SmartLink Modem driver for: slamr0. Creating /dev/modem symlink, pointing to: /dev/ttySL0. ciornj@deskubu904:~$ dmesg | tail -15 [18382.704303] option1 ttyUSB3: GSM modem (1-port) converter now disconnected from ttyUSB3 [18382.704325] option 1-3.4:1.3: device disconnected [18382.704562] option1 ttyUSB4: GSM modem (1-port) converter now disconnected from ttyUSB4 [18382.704584] option 1-3.4:1.4: device disconnected [18382.704821] option1 ttyUSB5: GSM modem (1-port) converter now disconnected from ttyUSB5 [18382.704844] option 1-3.4:1.5: device disconnected [18385.064640] usbcore: deregistering interface driver option [18385.064688] USB Serial deregistering driver GSM modem (1-port) [18385.181436] USB Serial support registered for GSM modem (1-port) [18385.181509] usbcore: registered new interface driver option [18385.181514] option: v0.7.2:USB Driver for GSM modems [18557.178616] slamr: SmartLink AMRMO modem. [18557.178648] slamr: device 10b9:5459 is grabbed by another driver [18673.677840] device 10b9:5459 is grabbed by driver serial: try to release [18673.678951] serial 0000:02:02.0: PCI INT A disabled ciornj@deskubu904:~$ I restart pc and ciornj@deskubu904:~$ lsmod slamr 435496 0 ciornj@deskubu904:~$ dmesg | tail -15 [ 17.373406] NFSD: starting 90-second grace period [ 19.522396] vboxdrv: Trying to deactivate the NMI watchdog permanently... [ 19.522405] vboxdrv: Successfully done. [ 19.522409] vboxdrv: Found 2 processor cores. [ 19.523048] vboxdrv: fAsync=0 offMin=0x3f0 offMax=0x30f2 [ 19.525828] vboxdrv: TSC mode is 'synchronous', kernel timer mode is 'normal'. [ 19.525837] vboxdrv: Successfully loaded version 3.1.4 (interface 0x00100001). [ 21.617661] Bluetooth: BNEP (Ethernet Emulation) ver 1.3 [ 21.617667] Bluetooth: BNEP filters: protocol multicast [ 21.640490] Bridge firewalling registered [ 26.839640] skge eth0: enabling interface [ 26.843100] ADDRCONF(NETDEV_UP): eth0: link is not ready [ 29.847902] skge eth0: Link is up at 100 Mbps, full duplex, flow control both [ 29.848117] ADDRCONF(NETDEV_CHANGE): eth0: link becomes ready [ 40.104010] eth0: no IPv6 routers present ciornj@deskubu904:~$ sudo modprobe ungrab-winmodem [sudo] password for ciornj: ciornj@deskubu904:~$ sudo modprobe -r slamr ciornj@deskubu904:~$ lsmod Module Size Used by ungrab_winmodem 9984 0 ciornj@deskubu904:~$ sudo modprobe slamr ciornj@deskubu904:~$ lsmod Module Size Used by slamr 435496 0 ungrab_winmodem 9984 0 ciornj@deskubu904:~$ sudo slmodemd -c ITALY /dev/slamr0 error: mdm setup: cannot stat `/dev/slamr0': No such file or directory error: cannot setup device `/dev/slamr0' ciornj@deskubu904:~$ dmesg | tail -15 [ 21.617661] Bluetooth: BNEP (Ethernet Emulation) ver 1.3 [ 21.617667] Bluetooth: BNEP filters: protocol multicast [ 21.640490] Bridge firewalling registered [ 26.839640] skge eth0: enabling interface [ 26.843100] ADDRCONF(NETDEV_UP): eth0: link is not ready [ 29.847902] skge eth0: Link is up at 100 Mbps, full duplex, flow control both [ 29.848117] ADDRCONF(NETDEV_CHANGE): eth0: link becomes ready [ 40.104010] eth0: no IPv6 routers present [ 170.722312] device 10b9:5459 is grabbed by driver serial: try to release [ 170.724172] serial 0000:02:02.0: PCI INT A disabled [ 223.714548] slamr: SmartLink AMRMO modem. [ 223.714644] slamr: probe 10b9:5459 SL1800 card... [ 223.714662] slamr 0000:02:02.0: PCI INT A -> GSI 22 (level, low) -> IRQ 22 [ 223.716822] slamr: mc97 codec is SIL26 [ 223.717071] slamr: slamr0 is SL1800 card. ciornj@deskubu904:~$ Thanks very much, Arturo 2010/3/3 Marvin Stodolsky <marvin.stodolsky@xxxxxxxxx>: > Arturo, > > RE: FATAL: Error inserting ungrab_winmodem > (/lib/modules/2.6.28-18-generic/updates/dkms/ungrab-winmodem.ko): > Unknown symbol in module, or unknown parameter (see dmesg) > ----------------- > This is unexpected. Please try reinstalling the sl-modem-source package. > $ sudo apt-get remove sl-modem-source > and then reinstall. > > If you get the same error do: > $ dmesg | tail -15 > and send us the output. > > The should be function under 2.6.28-18-generic > > MarvS > > MarvS > > > On Tue, Mar 2, 2010 at 1:05 PM, Arturo Neri <ciornjeja@xxxxxxxxx> wrote: >> In a hard disk I have Ubuntu 8.10 kernel 2.6.27-14 and there modem run well. >> I installed the new release 9.04 in a new HD and before delete old I >> tried to install modules for modem into new. >> But I haven't chance. I installed: >> libasound2-dev >> sl-modem-source >> sl-modem-daemon >> but when I read lsmod there is only slamr module not ungrab-winmodem. >> I tried: >> ciornj@deskubu904:~$ sudo modprobe ungrab-winmodem debug=3 >> [sudo] password for ciornj: >> FATAL: Error inserting ungrab_winmodem >> (/lib/modules/2.6.28-18-generic/updates/dkms/ungrab-winmodem.ko): >> Unknown symbol in module, or unknown parameter (see dmesg) >> ciornj@deskubu904:~$ dmesg | grep ungrab-winmodem >> ciornj@deskubu904:~$ dmesg | grep slamr >> [ 14.767920] slamr: module license 'Smart Link Ltd.' taints kernel. >> [ 14.776133] slamr: SmartLink AMRMO modem. >> [ 14.776166] slamr: device 10b9:5459 is grabbed by another driver >> Can anyone help me? >> Or I must stay all time with old release. >> Arturo >> >
