Re: 11c11040Re: subscrib

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



MrvS,

I have done what "How to" was saying
but with this command:
$ sudo wvdialconf /etc/wvdial.conf

the answer was:
    "Editing `/etc/wvdial.conf'.

     Scanning your serial ports for a modem.

     Modem Port Scan<*1>: S0   S1   S2   S3   Segmentation fault"

and "How to" says that a success will end with something else.

thank you

Amirreza



On Fri, Oct 24, 2008 at 11:38 PM, Marvin Stodolsky
<marvin.stodolsky@xxxxxxxxx> wrote:
> Amir,
>
>  /dev/ttyS0  is not what your modem uses.
> You must manually
> $ sudo modprobe agrmodem
> $ sudo modprobe agrserial
> which should announce creation of /dev/ttyAGR3
>
> If so follow the additional directions in the agrsm_howto.txt
>
> Report back presently
>
> MarvS
>
> On Fri, Oct 24, 2008 at 2:13 PM, Amir Reza Mousavi <amirreza.m@xxxxxxxxx> wrote:
>> MarvS,
>>
>> I dont want to take your time any more but still have the problem.
>>
>> Already i have installed agrsm-ubuntu8.04.1-2.6.24-19-generic.tar.gz
>> But my modem still not working.
>>
>>  In System > Administration > Network I used the both /dev/modem and
>> /dev/ttys0 as modem port but my modem still not working.
>>
>> On Fri, Oct 24, 2008 at 3:51 AM, Marvin Stodolsky
>> <marvin.stodolsky@xxxxxxxxx> wrote:
>>> Amir,
>>>
>>> The drivers are already compiled in agrsm-ubuntu8.04.1-2.6.24-19-generic.tar.gz
>>> Within the agrsm-ubuntu8.04.1-2.6.24-19-generic/   folder, just do
>>> $ sudo   ./setup
>>>
>>> MarvS
>>>
>>> On Thu, Oct 23, 2008 at 3:48 PM, Amir Reza Mousavi <amirreza.m@xxxxxxxxx> wrote:
>>>> MarvS,
>>>> as you have told me, at first i downloaded
>>>> "agrsm-ubuntu8.04.1-2.6.24-19-generic.tar.gz"
>>>> then i used the instruction that you have written, in your last email.
>>>> after that i read How to file in the folder of uncompresed
>>>> "agrsm-ubuntu8.04.1-2.6.24-19-generic.tar.gz"
>>>> and then i tried to install "agrsm-20080626.tar.gz" with the
>>>> instruction of How to
>>>> when i used command " sudo make install", terminal showed this:
>>>>
>>>> "Installing Agere Softmodem driver version 2.1.80-Red Flag NE 5.0
>>>> some files needed for installation are missing"
>>>>
>>>> what should i do?
>>>> thanks for your concern and your answers.
>>>>
>>>> Amirreza
>>>>
>>>> On Wed, Oct 22, 2008 at 5:01 AM, Marvin Stodolsky
>>>> <marvin.stodolsky@xxxxxxxxx> wrote:
>>>>> Amir
>>>>>
>>>>> Under Linux, unpack the attached with
>>>>>
>>>>> $ tar zxf agrsm*.tar.gz
>>>>> This will create a folder agrsm-ubuntu8.04.1-2.6.24-19-generic/
>>>>> Browse the files in the folder,
>>>>> Move into it with
>>>>> $ cd  agrsm-ubuntu8.04.1-2.6.24-19-generic
>>>>>
>>>>> Display the files with:
>>>>> $ ls
>>>>>
>>>>> Then run
>>>>> $ sudo  ./setup
>>>>>
>>>>> Read the files on how to proceed further.
>>>>> If help is needed, write to the List, not me directly.
>>>>>
>>>>> MarvS
>>>>>
>>>>>
>>>>>
>>>>>
>>>>>
>>>>>
>>>>> CPU=i686,
>>>>> Linux version 2.6.24-19-generic (buildd@palmer) (gcc version 4.2.3
>>>>> (Ubuntu 4.2.3-2ubuntu7))
>>>>>
>>>>> For candidate card in slot 00:1b.0, firmware information and bootup
>>>>> diagnostics are:
>>>>>  PCI slot       PCI ID          SubsystemID     Name
>>>>>  ----------     ---------       ---------       --------------
>>>>>  00:1b.0        8086:284b       107b:0690       Audio device: Intel Corporation 82801H
>>>>>
>>>>>  Modem interrupt assignment and sharing:
>>>>>  22:       1689          0   IO-APIC-fasteoi   HDA Intel
>>>>>  --- Bootup diagnostics for card in PCI slot 00:1b.0 ----
>>>>> [   56.556584] ACPI: PCI Interrupt 0000:00:1b.0[A] -> GSI 22 (level,
>>>>> low) -> IRQ 22
>>>>> [   56.556603] PCI: Setting latency timer of device 0000:00:1b.0 to 64
>>>>>
>>>>> The ALSA verion is 1.0.16
>>>>>
>>>>> The /proc/asound/pcm file reports:
>>>>> -----------------------
>>>>> 00-01: STAC92xx Digital : STAC92xx Digital : playback 1
>>>>> 00-00: STAC92xx Analog : STAC92xx Analog : playback 1 : capture 2
>>>>>
>>>>> about /proc/asound/cards:
>>>>> ------------------------
>>>>>  0 [Intel          ]: HDA-Intel - HDA Intel
>>>>>                      HDA Intel at 0xf4600000 irq 22
>>>>>
>>>>>  PCI slot 00:1b.0 has a High Definition Audio Card
>>>>>  The drivers are in the kernel modules tree at:
>>>>>  /lib/modules/2.6.24-19-generic/ubuntu/sound/alsa-driver/pci/hda/snd-hda-intel.ko
>>>>>  The modem codec file for the HDA card is: /proc/asound/card0/codec#1
>>>>> --------------------------------------------------------
>>>>> Codec: Generic 11c1 ID 1040
>>>>> Address: 1
>>>>> Vendor Id: 0x11c11040
>>>>>
>>>>>  For candidate modem in:  00:1b.0
>>>>>   0403 Audio device: Intel Corporation 82801H
>>>>>      Primary device ID:  8086:284b
>>>>>    Subsystem PCI_id  107b:0690
>>>>>    Softmodem codec or chipset from diagnostics: 0x11c11040
>>>>>                               from    Archives:
>>>>>                        The HDA card softmodem chip is 0x11c11040
>>>>>
>>>>>
>>>>> Support type needed or chipset: 11c11040
>>>>>
>>>>> AGRSM - At http://linmodems.technion.ac.il/packages/ltmodem/11c11040/
>>>>>
>>>>> MarvS
>>>>>
>>>>>
>>>>>  Minimal compiling resources appear complete:
>>>>>   make utility - /usr/bin/make
>>>>>   Compiler version 4.2
>>>>>   linuc_headers base folder /lib/modules/2.6.24-19-generic/build
>>>>>
>>>>>
>>>>> On Tue, Oct 21, 2008 at 11:51 AM, Amir Reza Mousavi
>>>>> <amirreza.m@xxxxxxxxx> wrote:
>>>>>> hi,
>>>>>> here you can find modemdata
>>>>>> thanks for your answer
>>>>>>
>>>>>> On 10/19/08, Marvin Stodolsky <marvin.stodolsky@xxxxxxxxx> wrote:
>>>>>>> Amir,
>>>>>>>
>>>>>>> Please send the ModemData.txt to the List
>>>>>>>
>>>>>>> Marv
>>>>>>>
>>>>>>> On Fri, Oct 17, 2008 at 10:41 AM, Amir Reza Mousavi
>>>>>>> <amirreza.m@xxxxxxxxx> wrote:
>>>>>>>> hi
>>>>>>>>
>>>>>>>> please pardon me if my english is not good enough
>>>>>>>>
>>>>>>>> i have problem with installing my modem, in ubuntu 8.04.
>>>>>>>> with scanmodem i found an adress
>>>>>>>> "http://linmodems.technion.ac.il/packages/ltmodem/11c11040/";
>>>>>>>> then i tried to find a driver to instaling, but when i read the
>>>>>>>> 'Howto' text, i was comfused that how can i instal my driver.
>>>>>>>>
>>>>>>>> if you want i can send you my scanModem's text
>>>>>>>>
>>>>>>>> thanks in advance
>>>>>>>>
>>>>>>>
>>>>>>
>>>>>
>>>>
>>>
>>
>

[Index of Archives]     [Linux Media Development]     [Asterisk]     [DCCP]     [Netdev]     [X.org]     [Xfree86]     [Fedora Women]     [Linux USB]

  Powered by Linux