Leonardo Borda wrote: > > Hello, > > I have configured advanced routing with success using three (03) > network adapters ( ETH0, ETH1 and ETH2). > Now I have to configure an addittion range in the same Interface > ETH0 ( another internet ip range address ), so I would like to have TWO > different ranges at the same ETHERNET CARD ( in this case ETH0 ) AND > having advanced routing running it. > I Did the same configurations as I already done it before and it is > not working. When testing through the secondary ip address the packets > get out from the wrong default gateway, however testing from primary > range I am able to route. > > Is it possible to do advanced routing having in the same Interface > TWO different ip range address? > > Somebody had done this somewhere? > > Thanks in advanced > > -- > Atenciosamente, > > Leonardo Borda Leonardo, Have you Yahooed/googled this? IIRC, I came across several pages describing your desired setup while trying to decide how to deal with 3 NICs and two different IPS (therefore separate nets on each NIC). Again IIRC, I rejected these because they were not the correct solution for me. Sorry I can't be more help, but I do think your solution is "out there". -- gypsy _______________________________________________ LARTC mailing list LARTC@xxxxxxxxxxxxxxx http://mailman.ds9a.nl/cgi-bin/mailman/listinfo/lartc
