Fischer, Anna wrote:
Subject: Re: Network I/O performance
Fischer, Anna wrote:
I am running KVM with Fedora Core 8 on a 2.6.23 32-bit kernel. I use
the tun/tap device model and the Linux bridge kernel module to connect
my VM to the network. I have 2 10G Intel 82598 network devices (with
the ixgbe driver) attached to my machine and I want to do packet
routing in my VM (the VM has two virtual network interfaces
configured). Analysing the network performance of the standard QEMU
emulated NICs, I get less that 1G of throughput on those 10G links.
Surprisingly though, I don't really see CPU utilization being maxed
out. This is a dual core machine, and mpstat shows me that both CPUs
are about 40% idle. My VM is more or less unresponsive due to the high
network processing load while the host OS still seems to be in good
shape. How can I best tune this setup to achieve best possible
performance with KVM? I know there is virtIO and I know there is PCI
pass-through, but those models are not an option for me right now.
How many cpus are assigned to the guest? If only one, then 40% idle
equates to 100% of a core for the guest and 20% for housekeeping.
No, the machine has a dual core CPU and I have configured the guest with 2 CPUs. So I would want to see KVM using up to 200% of CPU, ideally. There is nothing else running on that machine.
Well, it really depends on the workload, whether it can utilize both vcpus.
If this is the case, you could try pinning the vcpu thread ("info cpus"
from the monitor) to one core. You should then see 100%/20% cpu load
distribution.
wrt emulated NIC performance, I'm guessing you're not doing tcp? If
you
were we might do something with TSO.
No, I am measuring UDP throughput performance. I have now tried using a different NIC model, and the e1000 model seems to achieve slightly better performance (CPU goes up to 110% only though). I have also been running virtio now, and while its performance with 2.6.20 was very poor too, when changing the guest kernel to 2.6.30, I get a reasonable performance and higher CPU utilization (e.g. it goes up to 180-190%). I have to throttle the incoming bandwidth though, because as soon as I go over a certain threshold, CPU goes back down to 90% and throughput goes down too.
Yes, there's a known issue with UDP, where we don't report congestion
and the queues start dropping packets. There's a patch for tun queued
for the next merge window; you'll need a 2.6.31 host for that IIRC
(Herbert?)
I have not seen this with Xen/VMware where I mostly managed to max out CPU completely before throughput performance did not go up anymore.
I have also realized that when using the tun/tap configuration with a bridge, packets are replicated on all tap devices when QEMU writes packets to the tun interface. I guess this is a limitation of tun/tap as it does not know to which tap device the packet has to go to. The tap device then eventually drops packets when the destination MAC is not its own, but it still receives the packet which causes more overhead in the system overall.
Right, I guess you'd see this with a real switch as well? Maybe have
your guest send a packet out once in a while so the bridge can learn its
MAC address (we do this after migration, for example).
--
Do not meddle in the internals of kernels, for they are subtle and quick to panic.
--
To unsubscribe from this list: send the line "unsubscribe kvm" in
the body of a message to majordomo@xxxxxxxxxxxxxxx
More majordomo info at http://vger.kernel.org/majordomo-info.html
