Op 25-09-2019 om 06:55 schreef Matt Roper:
> On Fri, Sep 20, 2019 at 01:42:21PM +0200, Maarten Lankhorst wrote:
>> We cannot switch between HQ and normal mode on GLK+, so only
>> add planes on platforms where it makes sense.
>>
>> We could probably restrict it even more to only add when scaler
>> users toggles between 1 and 2, but lets just leave it for now.
>>
>> Signed-off-by: Maarten Lankhorst <maarten.lankhorst@xxxxxxxxxxxxxxx>
>> ---
>> drivers/gpu/drm/i915/display/intel_atomic.c | 5 +++++
>> 1 file changed, 5 insertions(+)
>>
>> diff --git a/drivers/gpu/drm/i915/display/intel_atomic.c b/drivers/gpu/drm/i915/display/intel_atomic.c
>> index 158594e64bb9..c50e0b218bd6 100644
>> --- a/drivers/gpu/drm/i915/display/intel_atomic.c
>> +++ b/drivers/gpu/drm/i915/display/intel_atomic.c
>> @@ -421,6 +421,11 @@ int intel_atomic_setup_scalers(struct drm_i915_private *dev_priv,
>> */
>> if (!plane) {
>> struct drm_plane_state *state;
>> +
>> + /* No need to reprogram, we're not changing scaling mode */
>> + if (INTEL_GEN(dev_priv) >= 10 || IS_GEMINILAKE(dev_priv))
>> + continue;
>> +
> We could probably just combine this into the existing !plane condition
> and enhance the comment above that to say "Note that GLK+ scalers don't
> have a HQ mode so this isn't necessary on those platforms."
>
> Either way,
>
> Reviewed-by: Matt Roper <matthew.d.roper@xxxxxxxxx>
I changed the coment slightly, but we need the continue or we get a null pointer deref.
Thanks for review, pushed 6, 8, 9 and the first patch (although newer v5 version with Ville's R-B).
>
>> plane = drm_plane_from_index(&dev_priv->drm, i);
>> state = drm_atomic_get_plane_state(drm_state, plane);
>> if (IS_ERR(state)) {
>> --
>> 2.20.1
>>
>> _______________________________________________
>> Intel-gfx mailing list
>> Intel-gfx@xxxxxxxxxxxxxxxxxxxxx
>> https://lists.freedesktop.org/mailman/listinfo/intel-gfx
_______________________________________________
Intel-gfx mailing list
Intel-gfx@xxxxxxxxxxxxxxxxxxxxx
https://lists.freedesktop.org/mailman/listinfo/intel-gfx
