On Fri, Sep 20, 2019 at 01:42:21PM +0200, Maarten Lankhorst wrote:
> We cannot switch between HQ and normal mode on GLK+, so only
> add planes on platforms where it makes sense.
>
> We could probably restrict it even more to only add when scaler
> users toggles between 1 and 2, but lets just leave it for now.
>
> Signed-off-by: Maarten Lankhorst <maarten.lankhorst@xxxxxxxxxxxxxxx>
> ---
> drivers/gpu/drm/i915/display/intel_atomic.c | 5 +++++
> 1 file changed, 5 insertions(+)
>
> diff --git a/drivers/gpu/drm/i915/display/intel_atomic.c b/drivers/gpu/drm/i915/display/intel_atomic.c
> index 158594e64bb9..c50e0b218bd6 100644
> --- a/drivers/gpu/drm/i915/display/intel_atomic.c
> +++ b/drivers/gpu/drm/i915/display/intel_atomic.c
> @@ -421,6 +421,11 @@ int intel_atomic_setup_scalers(struct drm_i915_private *dev_priv,
> */
> if (!plane) {
> struct drm_plane_state *state;
> +
> + /* No need to reprogram, we're not changing scaling mode */
> + if (INTEL_GEN(dev_priv) >= 10 || IS_GEMINILAKE(dev_priv))
> + continue;
> +
We could probably just combine this into the existing !plane condition
and enhance the comment above that to say "Note that GLK+ scalers don't
have a HQ mode so this isn't necessary on those platforms."
Either way,
Reviewed-by: Matt Roper <matthew.d.roper@xxxxxxxxx>
> plane = drm_plane_from_index(&dev_priv->drm, i);
> state = drm_atomic_get_plane_state(drm_state, plane);
> if (IS_ERR(state)) {
> --
> 2.20.1
>
> _______________________________________________
> Intel-gfx mailing list
> Intel-gfx@xxxxxxxxxxxxxxxxxxxxx
> https://lists.freedesktop.org/mailman/listinfo/intel-gfx
--
Matt Roper
Graphics Software Engineer
VTT-OSGC Platform Enablement
Intel Corporation
(916) 356-2795
_______________________________________________
Intel-gfx mailing list
Intel-gfx@xxxxxxxxxxxxxxxxxxxxx
https://lists.freedesktop.org/mailman/listinfo/intel-gfx
