Styma, Robert E (Robert) wrote:
I have included the vnc module in X configuration but any attempt to
connect to the server via vncviewer results in X crashing. In
the screen
section of xorg.conf I have set 'Option "securityTypes"
"None"' which
works fine for enabling remote connections in FC3 - FC5.
Also, I am unable to use blender because the interface does not draw
fully or correctly. And xawtv only works after a fresh boot,
after the
system has been up and used for a good time the output is
black though
audio still works.
My video card is a Radeon 7200.
I have had similar issues on FC6 and beyond. The default xorg.conf
file does not have a modules section. It is determining what to
load by other means. When I added the section with just a
module vnc statement, it dropped loading some other modules which
caused errors. My workaround was to scan the /var/log/Xorg.0.log
to see what modules were loaded and then put them in the modules
section. The operation is still a bit flakey. It does not work
as well as it did in fc2-fc5. I get a lot of screen artifacts.
I raised this question on both this list and the Xorg list with
no usable results. Maybe I will try the VNC list. There is
a related bugzilla, but it has not gone anywhere.
Bob Styma
Phoenix, AZ
I removed the "Module" section from xorg.conf and now when I connect via
vncviewer KDE desktop sharing automatically starts --so that was
probably why X was crashing when I had the vnc module loaded.
Changing xorg.conf did not help bender, it is still pretty much unusable.
-J
--
fedora-test-list mailing list
fedora-test-list@xxxxxxxxxx
To unsubscribe:
https://www.redhat.com/mailman/listinfo/fedora-test-list
