> > I have included the vnc module in X configuration but any attempt to > connect to the server via vncviewer results in X crashing. In > the screen > section of xorg.conf I have set 'Option "securityTypes" > "None"' which > works fine for enabling remote connections in FC3 - FC5. > > Also, I am unable to use blender because the interface does not draw > fully or correctly. And xawtv only works after a fresh boot, > after the > system has been up and used for a good time the output is > black though > audio still works. > > My video card is a Radeon 7200. > I have had similar issues on FC6 and beyond. The default xorg.conf file does not have a modules section. It is determining what to load by other means. When I added the section with just a module vnc statement, it dropped loading some other modules which caused errors. My workaround was to scan the /var/log/Xorg.0.log to see what modules were loaded and then put them in the modules section. The operation is still a bit flakey. It does not work as well as it did in fc2-fc5. I get a lot of screen artifacts. I raised this question on both this list and the Xorg list with no usable results. Maybe I will try the VNC list. There is a related bugzilla, but it has not gone anywhere. Bob Styma Phoenix, AZ -- fedora-test-list mailing list fedora-test-list@xxxxxxxxxx To unsubscribe: https://www.redhat.com/mailman/listinfo/fedora-test-list
