Hi dillon min > > okay, thanks alexandre, i will go through these docs. currently i'm on may > day holiday, will be back at next wensday. > after go back to work. i will separate this patch to five part with 9 > patchs , should be more clear > > dts releated > 1, ARM: dts: stm32: Add i2c3 node for stm32f429 > 2, ARM: dts: stm32: Add drm panel ili9341 nodes connect to ldtc > support for stm32f429-disco board > 3, ARM: dts: stm32: Add stmpe811 touch screen support for > stm32f429-disco board > 4, ARM: dts: stm32: Add l3gd20 gyroscope sensor support for > stm32f429-disco board > > clk releated > 1, clk: stm32: Fix ltdc loading hang in set clk rate, pll_hw set to > clks[PLL_VCO_SAI] but not clks[PLL_SAI] > 2, clk: stm32: Add CLK_IGNORE_UNUSED flags for ltdc, make sure ltdc clk > not be released after system startup > > spi releated > 1, spi: stm32: Add transfer mode SPI_SIMPLE_RX, SPI_3WIRE_RX support > for stm32f4 > > drm releated > 1, drm/panel: Add panel driver ilitek-ili9341 > > doc releated > 1, dt-bindings: display: panel: Add binding document for Ilitek Ili9341 Patch separation looks good. Please cc: me on both the binding and the panel patches. The binding must be in DT Schema format (.yaml). See a lot of examples in drm-misc-next for inspiration. Looks forward to see/review your submission. Sam _______________________________________________ dri-devel mailing list dri-devel@xxxxxxxxxxxxxxxxxxxxx https://lists.freedesktop.org/mailman/listinfo/dri-devel
