On 29.05.2023 16:40, Matthias Brugger wrote:
On 12/04/2023 19:06, Arınç ÜNAL wrote:
On 12.04.2023 19:53, Frank Wunderlich wrote:
Hi
Gesendet: Mittwoch, 12. April 2023 um 18:21 Uhr
Von: "Arınç ÜNAL" <arinc.unal@xxxxxxxxxx>
thanks, it changes the master when i upgrade iproute to 6.1 (from
debian bullseye-backports), but i cannot do any traffic on it after
switching to gmac1...
5: wan@eth1: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc
noqueue state UP group default qlen 1000
link/ether f2:d2:51:56:cd:3d brd ff:ff:ff:ff:ff:ff
inet 192.168.0.11/24 scope global wan
valid_lft forever preferred_lft forever
see no p5-TX/gmac-rx
Did you apply the vlan and flooding fix patches from Richard?
have now applied all patches i've found from richard (which are all
rejected):
fe4495bb3cc2 2023-02-12 Fix setting up CPU and User ports to be in
the correct mode during setup and when toggling vlan_filtering on a
bridge port. (HEAD -> 6.3-rc)
b0641f3e1a69 2023-02-12 Fix Flooding: Disable by default on User
ports and Enable on CPU ports
cb04b3451524 2023-02-12 Do not add all User ports to the CPU by
default. This will break Multi CPU when added a seperate patch. It
will be overwritten by .port_enable and since we are forcing output
to a port via the Special Tag this is not needed.
and now it seems working and is clear ;)
root@bpi-r2:~# ip l show wan
5: wan@eth1: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc noqueue
state UP mode DEFAULT group default qlen 1000
link/ether f2:d2:51:56:cd:3d brd ff:ff:ff:ff:ff:ff
iperf3
[ ID] Interval Transfer Bitrate Retr
[ 5] 0.00-10.00 sec 1.09 GBytes 940 Mbits/sec 0
sender
[ 5] 0.00-10.03 sec 1.09 GBytes 936 Mbits/sec
receiver
iperf3 -R
[ ID] Interval Transfer Bitrate Retr
[ 5] 0.00-10.04 sec 1.09 GBytes 936 Mbits/sec 0
sender
[ 5] 0.00-10.00 sec 1.09 GBytes 938 Mbits/sec
receiver
how do you deal with these patches? do you include them into your
mt7530 fixes series? they (and vladimirs preferred cpu-port) need to
be applied before these DTS-changes
Dealing with this is the last step on my tasklist. Take a look:
https://arinc9.notion.site/mt7530-c-improvements-bbfdc2ceb958484b9627297b88bc6d4a
I'm a bit lost here. @frank can this be merged now or are there still
oustanding issues. It seems to me that not, but just in case...
I fixed the network connectivity issue on the MT7530 DSA sudriver which
was the main problem this patch series would cause. I don't see an issue
that should block this series anymore.
With the current MT7530 DSA sudriver, port 5 will be the active CPU port
instead of 6. I've got a patch series to prefer port 6 instead but in
the meantime, this patch series should be good to apply.
Arınç
