On 28/03/2019 14:31, Rob Herring wrote:
On Tue, Mar 12, 2019 at 02:35:17PM +0530, Vignesh Raghavendra wrote:
Add dt bindings for TI syscon gate clock.
Signed-off-by: Vignesh Raghavendra <vigneshr@xxxxxx>
---
.../bindings/clock/ti,syscon-gate-clock.txt | 35 +++++++++++++++++++
1 file changed, 35 insertions(+)
create mode 100644 Documentation/devicetree/bindings/clock/ti,syscon-gate-clock.txt
diff --git a/Documentation/devicetree/bindings/clock/ti,syscon-gate-clock.txt b/Documentation/devicetree/bindings/clock/ti,syscon-gate-clock.txt
new file mode 100644
index 000000000000..f2bc4281ddba
--- /dev/null
+++ b/Documentation/devicetree/bindings/clock/ti,syscon-gate-clock.txt
@@ -0,0 +1,35 @@
+TI syscon gate clock
+
+The gate clock node must be provided inside a system controller node.
+
+Required:
+- comaptible: Must be "ti,syscon-gate-clock"
+- reg: Offset of register that controls the clock within syscon regmap
+- ti,clock-bit-idx: bit index that control gate/ungating of clock
+- clocks: phandle to the clock parent
+- #clock-cells: must be <0>
+
+Example:
+ ctrlmmr_epwm_ctrl: syscon@104140{
+ compatible = "syscon", "simple-bus";
Can't be both of these...
Is this a hard requirement? We seem to have few instances in the various
DTS files for various vendors where this is done, syscon is paired with
simple-mfd or simple-bus, or something else.
Basically, syscon by itself does not probe its children, and you can't
have the simple syscon support from kernel side if you don't have the
syscon compatible. Alternative is that we don't add any of the syscon
children under the syscon but add them as separate nodes outside it.
The above is not an issue for this patch itself if we ditch the separate
clock nodes, but it is more of a question about the syscon functionality
itself.
-Tero
+ reg = <0x0 0x104140 0x0 0x18>;
+ ranges = <0x0 0x0 0x104140>;
+ #address-cells = <1>;
+ #size-cells = <0>;
+
+ ehrpwm0_tbclk: clk@0 {
+ compatible = "ti,syscon-gate-clock";
+ reg = <0x0>;
+ #clock-cells = <0>;
+ clocks = <&k3_clks 40 0>;
+ ti,clock-bit-idx = <0>;
This would imply you have multiple nodes at one address which is
discouraged.
+ };
We generally don't describe clocks as 1 clock per node. Give the parent
a specific compatible and make it a clock provider.
+
+ ehrpwm1_tbclk: clk@4 {
+ compatible = "ti,syscon-gate-clock";
+ reg = <0x4>;
+ #clock-cells = <0>;
+ clocks = <&k3_clks 41 0>;
+ ti,clock-bit-idx = <0>;
+ };
+ };
--
2.21.0
--
Texas Instruments Finland Oy, Porkkalankatu 22, 00180 Helsinki. Y-tunnus/Business ID: 0615521-4. Kotipaikka/Domicile: Helsinki
