On Wed, Mar 16, 2016 at 09:26:38PM -0500, David Lechner wrote: > Device tree binding for new phy-da8xx-usb driver. > > Signed-off-by: David Lechner <david@xxxxxxxxxxxxxx> > --- > > v2 changes: This is new patch in v2. > > > .../devicetree/bindings/phy/phy-da8xx-usb.txt | 34 ++++++++++++++++++++++ > 1 file changed, 34 insertions(+) > create mode 100644 Documentation/devicetree/bindings/phy/phy-da8xx-usb.txt > > diff --git a/Documentation/devicetree/bindings/phy/phy-da8xx-usb.txt b/Documentation/devicetree/bindings/phy/phy-da8xx-usb.txt > new file mode 100644 > index 0000000..ed6b710 > --- /dev/null > +++ b/Documentation/devicetree/bindings/phy/phy-da8xx-usb.txt > @@ -0,0 +1,34 @@ > +TI DaVinci DA8XX USB PHY > + > +Required properties: > + - compatible: must be "ti,da830-usbphy". > + - #phy-cells: must be 1. > + - reg : Address and length of the CFGCHIP2 register. > + > +This device controls the PHY for both the USB 1.1 OHCI and USB 2.0 OTG > +controllers on DA8XX SoCs. Consumers of this device should use index 1 for DA8xx > +the USB 1.1 phy device and index 2 for the USB 2.0 phy device. > + > +Example: > + > + usbphy: usbphy@1c14184 { TI has been doing the unit addresses wrong I've recently found. It should match the reg property, not be the full physical address. Please fix all these in the example. > + compatible = "ti,da830-usbphy"; > + #phy-cells = <1>; > + reg = <0x14184 4>; > + }; > + > + usb11: usb11@1e25000 { usb@... > + compatible = "ti,da830-ohci"; > + reg = <0x225000 0x1000>; > + interrupts = <59>; > + phys = <&usbphy 1>; > + phy-names = "usbphy"; > + }; > + > + usb20: usb@1e00000 { > + compatible = "ti,da830-musb"; > + reg = <0x200000 0x1000>; > + interrupts = <58>; > + phys = <&usbphy 2>; > + phy-names = "usbphy"; > + }; > -- > 1.9.1 > -- To unsubscribe from this list: send the line "unsubscribe devicetree" in the body of a message to majordomo@xxxxxxxxxxxxxxx More majordomo info at http://vger.kernel.org/majordomo-info.html