Hi,
I still have this problem in v0.60.
If I stop one OSD, the OSD get set down after 20 seconds. But after 300
seconds the OSD get not set out, there for the ceph stays degraded for ever.
I can reproduce it with a fresh created cluster.
root@store1:~# ceph -s
health HEALTH_WARN 405 pgs degraded; 405 pgs stuck unclean; recovery
10603/259576 degraded (4.085%); 1/24 in osds are down
monmap e1: 3 mons at
{a=192.168.195.31:6789/0,b=192.168.195.33:6789/0,c=192.168.195.35:6789/0},
election epoch 10, quorum 0,1,2 a,b,c
osdmap e150: 24 osds: 23 up, 24 in
pgmap v12028: 4800 pgs: 4395 active+clean, 405 active+degraded; 505
GB data, 1017 GB used, 173 TB / 174 TB avail; 0B/s rd, 6303B/s wr,
2op/s; 10603/259576 degraded (4.085%)
mdsmap e1: 0/0/1 up
-martin
On 28.03.2013 23:45, John Wilkins wrote:
> Martin,
>
> I'm just speculating: since I just rewrote the networking section and
> there is an empty mon_host value, and I do recall a chat last week
> where mon_host was considered a different setting now, maybe you might
> try specifying:
>
> [mon.a]
> mon host = store1
> mon addr = 192.168.195.31:6789
>
> etc. for monitors. I'm assuming that's not the case, but I want to
> make sure my docs are right on this point.
>
>
> On Thu, Mar 28, 2013 at 3:24 PM, Martin Mailand <martin@xxxxxxxxxxxx> wrote:
>> Hi John,
>>
>> my ceph.conf is a bit further down in this email.
>>
>> -martin
>>
>> Am 28.03.2013 23:21, schrieb John Wilkins:
>>
>>> Martin,
>>>
>>> Would you mind posting your Ceph configuration file too? I don't see
>>> any value set for "mon_host": ""
>>>
>>> On Thu, Mar 28, 2013 at 1:04 PM, Martin Mailand <martin@xxxxxxxxxxxx>
>>> wrote:
>>>>
>>>> Hi Greg,
>>>>
>>>> the dump from mon.a is attached.
>>>>
>>>> -martin
>>>>
>>>> On 28.03.2013 20:55, Gregory Farnum wrote:
>>>>>
>>>>> Hmm. The monitor code for checking this all looks good to me. Can you
>>>>> go to one of your monitor nodes and dump the config?
>>>>>
>>>>> (http://ceph.com/docs/master/rados/configuration/ceph-conf/?highlight=admin%20socket#viewing-a-configuration-at-runtime)
>>>>> -Greg
>>>>>
>>>>> On Thu, Mar 28, 2013 at 12:33 PM, Martin Mailand <martin@xxxxxxxxxxxx>
>>>>> wrote:
>>>>>>
>>>>>> Hi,
>>>>>>
>>>>>> I get the same behavior an new created cluster as well, no changes to
>>>>>> the cluster config at all.
>>>>>> I stop the osd.1, after 20 seconds it got marked down. But it never get
>>>>>> marked out.
>>>>>>
>>>>>> ceph version 0.59 (cbae6a435c62899f857775f66659de052fb0e759)
>>>>>>
>>>>>> -martin
>>>>>>
>>>>>> On 28.03.2013 19:48, John Wilkins wrote:
>>>>>>>
>>>>>>> Martin,
>>>>>>>
>>>>>>> Greg is talking about noout. With Ceph, you can specifically preclude
>>>>>>> OSDs from being marked out when down to prevent rebalancing--e.g.,
>>>>>>> during upgrades, short-term maintenance, etc.
>>>>>>>
>>>>>>>
>>>>>>> http://ceph.com/docs/master/rados/operations/troubleshooting-osd/#stopping-w-out-rebalancing
>>>>>>>
>>>>>>> On Thu, Mar 28, 2013 at 11:12 AM, Martin Mailand <martin@xxxxxxxxxxxx>
>>>>>>> wrote:
>>>>>>>>
>>>>>>>> Hi Greg,
>>>>>>>>
>>>>>>>> setting the osd manually out triggered the recovery.
>>>>>>>> But now it is the question, why is the osd not marked out after 300
>>>>>>>> seconds? That's a default cluster, I use the 0.59 build from your
>>>>>>>> site.
>>>>>>>> And I didn't change any value, except for the crushmap.
>>>>>>>>
>>>>>>>> That's my ceph.conf.
>>>>>>>>
>>>>>>>> -martin
>>>>>>>>
>>>>>>>> [global]
>>>>>>>> auth cluster requierd = none
>>>>>>>> auth service required = none
>>>>>>>> auth client required = none
>>>>>>>> # log file = ""
>>>>>>>> log_max_recent=100
>>>>>>>> log_max_new=100
>>>>>>>>
>>>>>>>> [mon]
>>>>>>>> mon data = /data/mon.$id
>>>>>>>> [mon.a]
>>>>>>>> host = store1
>>>>>>>> mon addr = 192.168.195.31:6789
>>>>>>>> [mon.b]
>>>>>>>> host = store3
>>>>>>>> mon addr = 192.168.195.33:6789
>>>>>>>> [mon.c]
>>>>>>>> host = store5
>>>>>>>> mon addr = 192.168.195.35:6789
>>>>>>>> [osd]
>>>>>>>> journal aio = true
>>>>>>>> osd data = /data/osd.$id
>>>>>>>> osd mount options btrfs = rw,noatime,nodiratime,autodefrag
>>>>>>>> osd mkfs options btrfs = -n 32k -l 32k
>>>>>>>>
>>>>>>>> [osd.0]
>>>>>>>> host = store1
>>>>>>>> osd journal = /dev/sdg1
>>>>>>>> btrfs devs = /dev/sdc
>>>>>>>> [osd.1]
>>>>>>>> host = store1
>>>>>>>> osd journal = /dev/sdh1
>>>>>>>> btrfs devs = /dev/sdd
>>>>>>>> [osd.2]
>>>>>>>> host = store1
>>>>>>>> osd journal = /dev/sdi1
>>>>>>>> btrfs devs = /dev/sde
>>>>>>>> [osd.3]
>>>>>>>> host = store1
>>>>>>>> osd journal = /dev/sdj1
>>>>>>>> btrfs devs = /dev/sdf
>>>>>>>> [osd.4]
>>>>>>>> host = store2
>>>>>>>> osd journal = /dev/sdg1
>>>>>>>> btrfs devs = /dev/sdc
>>>>>>>> [osd.5]
>>>>>>>> host = store2
>>>>>>>> osd journal = /dev/sdh1
>>>>>>>> btrfs devs = /dev/sdd
>>>>>>>> [osd.6]
>>>>>>>> host = store2
>>>>>>>> osd journal = /dev/sdi1
>>>>>>>> btrfs devs = /dev/sde
>>>>>>>> [osd.7]
>>>>>>>> host = store2
>>>>>>>> osd journal = /dev/sdj1
>>>>>>>> btrfs devs = /dev/sdf
>>>>>>>> [osd.8]
>>>>>>>> host = store3
>>>>>>>> osd journal = /dev/sdg1
>>>>>>>> btrfs devs = /dev/sdc
>>>>>>>> [osd.9]
>>>>>>>> host = store3
>>>>>>>> osd journal = /dev/sdh1
>>>>>>>> btrfs devs = /dev/sdd
>>>>>>>> [osd.10]
>>>>>>>> host = store3
>>>>>>>> osd journal = /dev/sdi1
>>>>>>>> btrfs devs = /dev/sde
>>>>>>>> [osd.11]
>>>>>>>> host = store3
>>>>>>>> osd journal = /dev/sdj1
>>>>>>>> btrfs devs = /dev/sdf
>>>>>>>> [osd.12]
>>>>>>>> host = store4
>>>>>>>> osd journal = /dev/sdg1
>>>>>>>> btrfs devs = /dev/sdc
>>>>>>>> [osd.13]
>>>>>>>> host = store4
>>>>>>>> osd journal = /dev/sdh1
>>>>>>>> btrfs devs = /dev/sdd
>>>>>>>> [osd.14]
>>>>>>>> host = store4
>>>>>>>> osd journal = /dev/sdi1
>>>>>>>> btrfs devs = /dev/sde
>>>>>>>> [osd.15]
>>>>>>>> host = store4
>>>>>>>> osd journal = /dev/sdj1
>>>>>>>> btrfs devs = /dev/sdf
>>>>>>>> [osd.16]
>>>>>>>> host = store5
>>>>>>>> osd journal = /dev/sdg1
>>>>>>>> btrfs devs = /dev/sdc
>>>>>>>> [osd.17]
>>>>>>>> host = store5
>>>>>>>> osd journal = /dev/sdh1
>>>>>>>> btrfs devs = /dev/sdd
>>>>>>>> [osd.18]
>>>>>>>> host = store5
>>>>>>>> osd journal = /dev/sdi1
>>>>>>>> btrfs devs = /dev/sde
>>>>>>>> [osd.19]
>>>>>>>> host = store5
>>>>>>>> osd journal = /dev/sdj1
>>>>>>>> btrfs devs = /dev/sdf
>>>>>>>> [osd.20]
>>>>>>>> host = store6
>>>>>>>> osd journal = /dev/sdg1
>>>>>>>> btrfs devs = /dev/sdc
>>>>>>>> [osd.21]
>>>>>>>> host = store6
>>>>>>>> osd journal = /dev/sdh1
>>>>>>>> btrfs devs = /dev/sdd
>>>>>>>> [osd.22]
>>>>>>>> host = store6
>>>>>>>> osd journal = /dev/sdi1
>>>>>>>> btrfs devs = /dev/sde
>>>>>>>> [osd.23]
>>>>>>>> host = store6
>>>>>>>> osd journal = /dev/sdj1
>>>>>>>> btrfs devs = /dev/sdf
>>>>>>>>
>>>>>>>>
>>>>>>>> On 28.03.2013 19:01, Gregory Farnum wrote:
>>>>>>>>>
>>>>>>>>> Your crush map looks fine to me. I'm saying that your ceph -s output
>>>>>>>>> showed the OSD still hadn't been marked out. No data will be
>>>>>>>>> migrated
>>>>>>>>> until it's marked out.
>>>>>>>>> After ten minutes it should have been marked out, but that's based
>>>>>>>>> on
>>>>>>>>> a number of factors you have some control over. If you just want a
>>>>>>>>> quick check of your crush map you can mark it out manually, too.
>>>>>>>>> -Greg
>>>>>>>>
>>>>>>>> _______________________________________________
>>>>>>>> ceph-users mailing list
>>>>>>>> ceph-users@xxxxxxxxxxxxxx
>>>>>>>> http://lists.ceph.com/listinfo.cgi/ceph-users-ceph.com
>>>>>>>
>>>>>>>
>>>>>>>
>>>>>>>
>>>
>>>
>>>
>>
>
>
>
_______________________________________________
ceph-users mailing list
ceph-users@xxxxxxxxxxxxxx
http://lists.ceph.com/listinfo.cgi/ceph-users-ceph.com
