hello! My problem is that i can't see what i'mdoing on my computer. i can mount a floppy or a zip dirve, but when i type cd to the directory where the device is mounted it doesn't work. it seems that my problem is that cd doesn't work. -----Ursprungligt meddelande----- Fr=E5n: blinux-list-admin@redhat.com [mailto:blinux-list-admin@redhat.com]F=F6r Cheryl Homiak Skickat: den 31 december 2001 05:32 Till: blinux-list@redhat.com =C4mne: Re: SV: ZIPSLACK Actually, zipslack is in some ways a better choice than brlspeak if you are using zipslack-8.0, as brlspeak, at least when I used it for a while, was based on zipspeak-7.0 and much older. I'm not sure why there is no current version of zipspeak or brlspeak. However, I also used zipslack as a backup on my DOS hard drive for a while, and it worked fine with brltty installed. I'm not sure I understand why you didn't just do a full compile; zipslack should support that. I actually didn't have to compile it; it was on the same machine as my debian system, so I just mounted the dos hard-drive with zipslack on it, as umsdos not as dos very important, and typed install-brltty /mnt/linux. Then I went in and started it up manually by typing "brltty" after logging in as root, and put the code in the right place to start it up at boot, per the brltty manual. I am comin= g in late on this discussion, but will be glad to help you further if we ca= n narrow down what your problem is. -- Cheryl _______________________________________________ Blinux-list@redhat.com https://listman.redhat.com/mailman/listinfo/blinux-list