At Wed, 15 Apr 2009 10:45:43 -0400, Jerry Geis wrote: > > > Takashi Iwai wrote: > > At Wed, 15 Apr 2009 10:00:33 -0400, > > Jerry Geis wrote: > > > >> I am using the gigabyte MA78GM-US2H motherboard. it has the ALC889A audio. > >> > >> I am trying 1.0.19 and audio works out the analog back port but not over > >> HDMI. > >> > > > > Never mind about "Function ID" entry. It's just a new line that was > > added recently. function_id=1 means it's an audio codec. > > > > The way HDMI is supported are mainly either through the same audio > > codec (ALC889A) or through a dedicated HDMI codec. In the former > > case, you'll likely see a word "HDMI" in the digital output pin of the > > codec proc file. In the latter case, you must have a different codec > > chip connected to the HD-audio bus with a different codec address > > number. > > > > > > Takashi > > > > > > > >> Codec: Realtek ALC889A > >> Address: 0 > >> Function Id: 0x1 > >> <--------------------------------- this is different > >> Vendor Id: 0x10ec0885 > >> Subsystem Id: 0x1458a002 > >> Revision Id: 0x100101 > >> No Modem Function Group found > >> Default PCM: > >> rates [0x560]: 44100 48000 96000 192000 > >> bits [0xe]: 16 20 24 > >> formats [0x1]: PCM > >> Default Amp-In caps: N/A > >> Default Amp-Out caps: N/A > >> GPIO: io=2, o=0, i=0, unsolicited=1, wake=0 > >> IO[0]: enable=0, dir=0, wake=0, sticky=0, data=0, unsol=0 > >> IO[1]: enable=0, dir=0, wake=0, sticky=0, data=0, unsol=0 > >> Node 0x02 [Audio Output] wcaps 0x11: Stereo > >> Converter: stream=0, channel=0 > >> PCM: > >> rates [0x560]: 44100 48000 96000 192000 > >> bits [0xe]: 16 20 24 > >> formats [0x1]: PCM > >> Node 0x03 [Audio Output] wcaps 0x11: Stereo > >> > >> I have been looking but havent found a solution yet. I tried grabbing > >> the snapshot tar ball for today but I get errors on the compile. > >> > >> I had a similiar motherboard but it does not report Function ID: 01 : - > >> HDMI audio on this board works correctly. > >> Codec: Realtek ALC889A > >> Address: 0 > >> Vendor Id: 0x10ec0885 > >> Subsystem Id: 0x1458a002 > >> Revision Id: 0x100101 > >> No Modem Function Group found > >> Default PCM: > >> rates [0x560]: 44100 48000 96000 192000 > >> > >> Any thoughts???? > >> > >> Jerry > >> _______________________________________________ > >> Alsa-devel mailing list > >> Alsa-devel@xxxxxxxxxxxxxxxx > >> http://mailman.alsa-project.org/mailman/listinfo/alsa-devel > >> > >> > > > > > > I upload alsa-info.sh > > for the NOT WORKIng one > http://www.alsa-project.org/db/?f=7e8bc9485e8bb98bf15dae5a0d5dc038003c3203 > > for the working on > http://www.alsa-project.org/db/?f=a18bcb6e87fe33a7365a749d0877a4546e901bf2 How are you testing HDMI output? Takashi _______________________________________________ Alsa-devel mailing list Alsa-devel@xxxxxxxxxxxxxxxx http://mailman.alsa-project.org/mailman/listinfo/alsa-devel
