Takashi Iwai wrote: > At Wed, 15 Apr 2009 10:00:33 -0400, > Jerry Geis wrote: > >> I am using the gigabyte MA78GM-US2H motherboard. it has the ALC889A audio. >> >> I am trying 1.0.19 and audio works out the analog back port but not over >> HDMI. >> > > Never mind about "Function ID" entry. It's just a new line that was > added recently. function_id=1 means it's an audio codec. > > The way HDMI is supported are mainly either through the same audio > codec (ALC889A) or through a dedicated HDMI codec. In the former > case, you'll likely see a word "HDMI" in the digital output pin of the > codec proc file. In the latter case, you must have a different codec > chip connected to the HD-audio bus with a different codec address > number. > > > Takashi > > > >> Codec: Realtek ALC889A >> Address: 0 >> Function Id: 0x1 >> <--------------------------------- this is different >> Vendor Id: 0x10ec0885 >> Subsystem Id: 0x1458a002 >> Revision Id: 0x100101 >> No Modem Function Group found >> Default PCM: >> rates [0x560]: 44100 48000 96000 192000 >> bits [0xe]: 16 20 24 >> formats [0x1]: PCM >> Default Amp-In caps: N/A >> Default Amp-Out caps: N/A >> GPIO: io=2, o=0, i=0, unsolicited=1, wake=0 >> IO[0]: enable=0, dir=0, wake=0, sticky=0, data=0, unsol=0 >> IO[1]: enable=0, dir=0, wake=0, sticky=0, data=0, unsol=0 >> Node 0x02 [Audio Output] wcaps 0x11: Stereo >> Converter: stream=0, channel=0 >> PCM: >> rates [0x560]: 44100 48000 96000 192000 >> bits [0xe]: 16 20 24 >> formats [0x1]: PCM >> Node 0x03 [Audio Output] wcaps 0x11: Stereo >> >> I have been looking but havent found a solution yet. I tried grabbing >> the snapshot tar ball for today but I get errors on the compile. >> >> I had a similiar motherboard but it does not report Function ID: 01 : - >> HDMI audio on this board works correctly. >> Codec: Realtek ALC889A >> Address: 0 >> Vendor Id: 0x10ec0885 >> Subsystem Id: 0x1458a002 >> Revision Id: 0x100101 >> No Modem Function Group found >> Default PCM: >> rates [0x560]: 44100 48000 96000 192000 >> >> Any thoughts???? >> >> Jerry >> _______________________________________________ >> Alsa-devel mailing list >> Alsa-devel@xxxxxxxxxxxxxxxx >> http://mailman.alsa-project.org/mailman/listinfo/alsa-devel >> >> > > I upload alsa-info.sh for the NOT WORKIng one http://www.alsa-project.org/db/?f=7e8bc9485e8bb98bf15dae5a0d5dc038003c3203 for the working on http://www.alsa-project.org/db/?f=a18bcb6e87fe33a7365a749d0877a4546e901bf2 I noticed the subsystem a002 and a022 is different. Can this be why its not working? Any thoughts? Jerry _______________________________________________ Alsa-devel mailing list Alsa-devel@xxxxxxxxxxxxxxxx http://mailman.alsa-project.org/mailman/listinfo/alsa-devel
