On Thu, 2019-05-09 at 15:14 -0400, Bob Goodwin wrote: > > On 05/09/19 07:23, Ed Greshko wrote: > > So, your network kinda looks like the attached. (no switch in my > > diagram) > > > > Your Viasat Modem has 2 interfaces. The interface that connects to > > the Radio Equipment, > > does it have an IP address? Do you know what it is? And the > > second interface connects to > > the switch and is 192.168.1.1. > . > Yeah, it "kinda" looks like that in some way ... > > The Viasat unit has the line that goes to the microwave equipment at > the > dish which I assume is something like a one GHz intermediate > frequency > signal modulated with the date. I have no access to that, it does > have > two ethernet ports they state are identical and apparently can be > used > interchangeably, at this moment one is connected to the ethernet > switch > and feeding this computer assigned the ip 192.168.1.47 by the > viasat > router dhcp server. If I put the viasat unit into it's bridged mode > I > would expect output as 182.168.1.1 but not sure of that. > > However they insist that bridged mode can not be used, I think > because > it kills the voip interface which is integral to the viasat > router/modem. > > You're saying the Modem and the ASUS are connected to the Switch. > > And you have other > > devices connected to the switch. Those other devices would have IP > > addresses of > > 192.168.1.X. Yes? Can you modify settings in the modem? it would be best if you could router 192/168.0.0/24 (255.255.0.0) to the router. Don't use NAT on the router in that case, but let it do DHCP on the LAN with a different IP- range 192.168.x where x is not 1. Port forwardings are then set on the Viasat to the internal addresses (192.168.x.y). So you use the router for routing and firewall, but not NAT. This is the cleanest solution. LAN stations van still access the Viasat through its 192.168 address if the router is properly configured and its firewall allows the traffic If the Viasat can do this it will work wonderfully... _______________________________________________ users mailing list -- users@xxxxxxxxxxxxxxxxxxxxxxx To unsubscribe send an email to users-leave@xxxxxxxxxxxxxxxxxxxxxxx Fedora Code of Conduct: https://getfedora.org/code-of-conduct.html List Guidelines: https://fedoraproject.org/wiki/Mailing_list_guidelines List Archives: https://lists.fedoraproject.org/archives/list/users@xxxxxxxxxxxxxxxxxxxxxxx
