On 12/5/18 5:45 PM, Peter Robinson wrote:
On 12/5/18 5:15 PM, Peter Robinson wrote:
U-Boot 2018.09 (Sep 11 2018 - 09:51:41 +0000) for ODROID-XU3/XU4/HC1
CPU: Exynos5422 @ 800 MHz
Model: Odroid XU3 based on EXYNOS5422
Board: Odroid XU3 based on EXYNOS5422
Type: hc1
DRAM: 2 GiB
MMC: EXYNOS DWMMC: 0, EXYNOS DWMMC: 2
Loading Environment from MMC... Card did not respond to voltage select!
*** Warning - No block device, using default environment
In: serial
Out: serial
Err: serial
Net: No ethernet found.
Hit any key to stop autoboot: 0
^^^^
How do I interrupt boot process at the right point (I assume at the
bootp point)?
Watch the screen.... it shows you, see your own output above, that
should count down from probably 2.
Ah, it has been so long. I was thinking about this. Once it autoboot
is interupted then you can step through or some such. I will give it a try.
thanks
_______________________________________________
arm mailing list -- arm@xxxxxxxxxxxxxxxxxxxxxxx
To unsubscribe send an email to arm-leave@xxxxxxxxxxxxxxxxxxxxxxx
Fedora Code of Conduct: https://getfedora.org/code-of-conduct.html
List Guidelines: https://fedoraproject.org/wiki/Mailing_list_guidelines
List Archives: https://lists.fedoraproject.org/archives/list/arm@xxxxxxxxxxxxxxxxxxxxxxx
