I don't know anything about lynxos but, apparently, the server is expecting that it can open /dev/atc0 to get access to the console. You apparently don't have /dev/atc0. So.... that either means you need /dev/atc0 in order to run XFree86 or if there is some other way to access the console on lynxos, you need a version of XFree86 that knows how to access it (I don't know if such a version exists or not). If this were Linux, I'd say you just forgot to compile your kernel with console and virtual terminal support. I have no experience with Lynxos, however, so I don't know if this is the same problem. Mark. On Fri, 15 Dec 2006, bheemappa wrote: > Hello, > > Am using lynxos 4.0.0 for powerpc sbc board, after i installed > xfree86 4.3.0 when,I try to configure the X server with configuration > command its giving an Fatal server error. > If any one knows the solution plese tel me > > reply to this id : bheemappa@xxxxxxxxxx > > Below is the detailed log. > > > > ############# LOG Start Here ######################### > > # XFree86 > _XSERVTransSocketCreateListener: failed to bind listener > _XSERVTransSocketINETCreateListener: ...SocketCreateListener() failed > _XSERVTransMakeAllCOTSServerListeners: failed to create listener for tcp > > XFree86 Version 4.3.0 > Release Date: 27 February 2003 > X Protocol Version 11, Revision 0, Release 6.6 > Build Operating System: LynxOS 4.0.0 PowerPC (LynuxWorks, Inc.) > Build Date: 16 December 2004 > Before reporting problems, check http://www.XFree86.Org/ > to make sure that you have the latest version. > Module Loader present > Markers: (--) probed, (**) from config file, (==) default setting, > (++) from command line, (!!) notice, (II) informational, > (WW) warning, (EE) error, (NI) not implemented, (??) unknown. > (==) Log file: "/usr/adm/XFree86.8.log", Time: Sat Nov 29 16:05:30 2003 > > Fatal server error: > xf86OpenConsole: Cannot open /dev/atc0 (No such device or address ) > > > When reporting a problem related to a server crash, please send > the full server output, not just the last messages. > This can be found in the log file "/usr/adm/XFree86.8.log". > Please report problems to xfree86@xxxxxxxxxxxx > > Failed to run "X -configure". > > ####################### Log Ends here ############################# > > > > Reagards > Bheema > > _______________________________________________ > XFree86 mailing list > XFree86@xxxxxxxxxxx > http://XFree86.Org/mailman/listinfo/xfree86 > _______________________________________________ XFree86 mailing list XFree86@xxxxxxxxxxx http://XFree86.Org/mailman/listinfo/xfree86
