Hello,
Am using lynxos 4.0.0 for powerpc sbc board, after i installed
xfree86 4.3.0 when,I try to configure the X server with configuration
command its giving an Fatal server error.
If any one knows the solution plese tel me
reply to this id : bheemappa@xxxxxxxxxx
Below is the detailed log.
############# LOG Start Here #########################
# XFree86
_XSERVTransSocketCreateListener: failed to bind listener
_XSERVTransSocketINETCreateListener: ...SocketCreateListener() failed
_XSERVTransMakeAllCOTSServerListeners: failed to create listener for tcp
XFree86 Version 4.3.0
Release Date: 27 February 2003
X Protocol Version 11, Revision 0, Release 6.6
Build Operating System: LynxOS 4.0.0 PowerPC (LynuxWorks, Inc.)
Build Date: 16 December 2004
Before reporting problems, check http://www.XFree86.Org/
to make sure that you have the latest version.
Module Loader present
Markers: (--) probed, (**) from config file, (==) default setting,
(++) from command line, (!!) notice, (II) informational,
(WW) warning, (EE) error, (NI) not implemented, (??) unknown.
(==) Log file: "/usr/adm/XFree86.8.log", Time: Sat Nov 29 16:05:30 2003
Fatal server error:
xf86OpenConsole: Cannot open /dev/atc0 (No such device or address )
When reporting a problem related to a server crash, please send
the full server output, not just the last messages.
This can be found in the log file "/usr/adm/XFree86.8.log".
Please report problems to xfree86@xxxxxxxxxxxx
Failed to run "X -configure".
####################### Log Ends here #############################
Reagards
Bheema
_______________________________________________
XFree86 mailing list
XFree86@xxxxxxxxxxx
http://XFree86.Org/mailman/listinfo/xfree86
