Duh. OK I get it now. I've never had any pci problems so I'm learning here,
bear with me! Here is the output for the card:
0000:00:10.0 VGA compatible controller: Cirrus Logic GD 5434-8 [Alpine] (rev
26) (prog-if 00 [VGA])
Control: I/O+ Mem+ BusMaster- SpecCycle- MemWINV- VGASnoop- ParErr-
Stepping- SERR- FastB2B-
Status: Cap- 66Mhz- UDF- FastB2B- ParErr- DEVSEL=fast >TAbort- <TAbort-
<MAbort- >SERR- <PERR-
Interrupt: pin A routed to IRQ 9
Region 0: Memory at f5000000 (32-bit, non-prefetchable) [size=16M]
Expansion ROM at <unassigned> [disabled] [size=16M]
Thanks for any insights!
SFK
--- Ryan Underwood <nemesis-lists@xxxxxxxxxxxx> wrote:
>
> On Fri, Jun 18, 2004 at 08:18:13PM -0700, Scott Kiesling wrote:
> > I am trying to configure xfree on an old machine which I have just
> installed
> > Gentoo on, but can't get it to start. The errors from the xfree log come up
> > like this:
> >
> > (EE) CIRRUS(0): No valid MMIO address in PCI config space
> > (EE) CIRRUS(0): I2C initialization failed
>
> Can you lspci -vvv and post the block corresponding to your card? Also,
> is this a PCI or ISA card?
>
> --
> Ryan Underwood, <nemesis@xxxxxxxxxxxx>
_______________________________________________
XFree86 mailing list
XFree86@xxxxxxxxxxx
http://XFree86.Org/mailman/listinfo/xfree86
