To force 60.1kHz / 60.1Hz, I tried setting the following mode line into the config:
Modeline "1280x1024" 108.18 1280 1328 1440 1688 1024 1025 1028 1066 +hsync +vsync
(see attached config file), but that didn't work. See attached log file
Apart from what Russel already said, you can't force the driver to use specific timing that way. Obviously (but without verifying this, though), the Modeline you entered does not result in exactly 60.1Khz which you gave as a single value in the Monitor section (hence the "Hsync out of range" message in the log). Give a (wider) range for HorizSync in the Monitor section, and play with the modeline later once it is accepted. Then you will also see in the log what horiz. frequency it results in.
Thomas
PS: And by the way, I recommend updating the SiS driver to the version from my website. It fixes quite a bunch of problems.
-- Thomas Winischhofer Vienna/Austria thomas AT winischhofer DOT net *** http://www.winischhofer.net/ twini AT xfree86 DOT org
_______________________________________________ XFree86 mailing list XFree86@xxxxxxxxxxx http://XFree86.Org/mailman/listinfo/xfree86
