On Thu, 29 Jan 2004 13:32:23 +0100, you wrote: > hello, > > i am using wine 20040121, and the windows application i am trying to run > need to communicate through the serial ports with an attached device. > the problem is this: whenever i try to communicate with the serial > device, i get the following error message: Matthias, There is not a single error in the debug trace that you posted. The one fixme is almost certainly harmless. I presume it does not work: how do you notice? Does the program report anything? > trace:comm:ClearCommError handle 0x164 cbInQue = 0 cbOutQue = 11 > trace:comm:ClearCommError handle 0x164 cbInQue = 0 cbOutQue = 11 These ClearCommError's are normally used by program's to check for bytes in the in- and output buffers. Here you see that the program has written 11 bytes. > trace:comm:ClearCommError handle 0x164 cbInQue = 0 cbOutQue = 0 Lots of those: the program waits for a response. > trace:comm:ClearCommError handle 0x164 cbInQue = 1 cbOutQue = 0 Here is an incoming byte. So the program appears to be communicating, hence my question what goes actually wrong? Adding the debug option "--debugmsg +file,+comm" might give more insight in the communication problem. The resulting output may be much bigger though, you will need to search the actual ReadFile and WriteFile calls that the program does to exchange data. Rein. -- Rein Klazes rklazes@xxxxxxxxx _______________________________________________ wine-users mailing list wine-users@xxxxxxxxxx http://www.winehq.org/mailman/listinfo/wine-users
