On 02/10/08 20:34, Magnus Andersson wrote: > Klaus Schmidinger wrote: >> Those Telenor channels are encrypted, so I'm afraid I can't test them. >> >> However, this may also be the reason for your problem. When VDR first switches >> to an encrypted channel, it always does so in Transfer-Mode, so that it can >> check whether the TS packets get decrypted. Once it knows that a channel can be >> decrypted, it switches to it in direct live mode if you switch to it again. >> >> While in Transfer-Mode, the high data rate stream is read from the FF card >> and sent back to it for replay. I assume this is too much load for the FF card. >> >> Try switching to the same channel again after some 15 seconds. Does it show >> up ok then? > > Yes it does. If I stay 15 seconds with bad picture and change to another > channel and back it works. I have to do that every time I restart vdr on > these channels. Is there a solution to this or do I have to buy new > hardware for VDR 1.6.0? I like VDR as it is now because I do not have > any HDTV channels or a LCD TV. > Why does it work in version 1.4.7? Version 1.4.7 simply switched to the encrypted channel and didn't check whether it was actually decrypted. Version 1.5 automatically selects a suitable CAM, and if there is more than one CAM that claims to be able to decrypt a given channel, it needs to check whether it actually can do so. Therefore it starts in Transfer-Mode, which is apparently a problem on FF cards with high bandwith channels. Too bad the CI standard is so broken... Klaus _______________________________________________ vdr mailing list vdr@xxxxxxxxxxx http://www.linuxtv.org/cgi-bin/mailman/listinfo/vdr
