On 02/02/08 11:35, Magnus Andersson wrote: > Klaus Schmidinger wrote: >> On 02/01/08 19:17, Magnus Andersson wrote: >> >>> Hello! >>> >>> I have problems with channels that uses high bitrate on Thor 1W. A few >>> channels uses between 10-11 Mbit/s mpeg2 and if I use tv-out from FF >>> card vdr 1.5.14 the picture glitches and the remote response becomes >>> really slow. It can take 10 seconds or more to change channel. There are >>> no problems if I use xineliboutput and vdr 1.5.14 or channels with low >>> bitrate. VDR 1.4.7 is ok with both xinliboutput plugin and tv-out from >>> FF card so my question is how to log this? I start vdr with option -l 3 >>> but there is nothing in the log. >>> >> >> Please post the channel definitions of some of these channels. >> >> Klaus >> >> _______________________________________________ >> vdr mailing list >> vdr@xxxxxxxxxxx >> http://www.linuxtv.org/cgi-bin/mailman/listinfo/vdr >> > > 24;Telenor:12303:vC34M0O0S0:S1.0W:27799:523:684=sve:576:B00:3012:70:16:0 > SVT2 ¬stNytt;Telenor:12303:vC34M0O0S0:S1.0W:27799:512:640=sve;641=sve:576:B00:3009:70:16:0 > 24 ¬stNytt;Telenor:12303:vC34M0O0S0:S1.0W:27799:523:684=sve:576:B00:3020:70:16:0 > > The problem is not always permanent but here a good way to reproduce the > problem. Restart vdr on BBC World (FTA) channel on Thor 1W and configure > vdr to start at last channel. > > BBC World;Telenor:11325:hC78M0O0S0:S1.0W:24500:513:644=eng:577:1:1001:70:25:0 > > > When BBC world has started tune one of the high bitrate channels and you > will see the problem. Those Telenor channels are encrypted, so I'm afraid I can't test them. However, this may also be the reason for your problem. When VDR first switches to an encrypted channel, it always does so in Transfer-Mode, so that it can check whether the TS packets get decrypted. Once it knows that a channel can be decrypted, it switches to it in direct live mode if you switch to it again. While in Transfer-Mode, the high data rate stream is read from the FF card and sent back to it for replay. I assume this is too much load for the FF card. Try switching to the same channel again after some 15 seconds. Does it show up ok then? Klaus _______________________________________________ vdr mailing list vdr@xxxxxxxxxxx http://www.linuxtv.org/cgi-bin/mailman/listinfo/vdr
