I am using vdr-1.5.13 - start vdr and switch to encrypted channel - set timer on encrypted channel one minute in advance from current time - switch to same Transponder with FTA channel, in my situation a radio channel - once the timer started I cannot switch back to the encrypted channel with message channel is not available. In the recordings list it shows the file but in 0 size. - stop timer is the only way to switch back to encrypted channel. Theunis On 08/02/2008, Klaus Schmidinger <Klaus.Schmidinger@xxxxxxxxxx> wrote: > > I tried to reproduce this here, but everything worked fine. > Here's what I did: > > - start VDR with only a single FF card with one CAM > - switch to an encrypted channel > => channel displays in live mode > - start a recording on that channel > => recording successful > - switch to an FTA channel on the same transponder > => channel displays in live mode > - start a recording on that channel > => recording successful > > At this point I had two recordings running on the same transponder, > one with an encrypted channel and one FTA. > > This also worked the other way round (first recording FTA, then encrypted). > > This was done with the version 1.5.13 code base. > > Does the problem still persist on your system with VDR 1.5.13? > > Klaus > > _______________________________________________ > vdr mailing list > vdr@xxxxxxxxxxx > http://www.linuxtv.org/cgi-bin/mailman/listinfo/vdr > _______________________________________________ vdr mailing list vdr@xxxxxxxxxxx http://www.linuxtv.org/cgi-bin/mailman/listinfo/vdr
