Since commit a5a4c1d5a3 ("dts: update to v5.13-rc1"), which synced kernel dts, USB-OTG port on phyFLEX board was set to work only in peripheral mode. This has to do with phyFLEX baseboard hardware bug, which prevents correct USB OTG ID pin detection in kernel code. Unlike linux kernel, barebox doesn't support OTG auto-detection mode via ID pin. In barebox, user has to select desired USB mode of operation by setting 'otg.mode' variable. Thus set the 'dr_mode' property to "otg" to be able to later select USB OTG operating mode at runtime (either host or peripheral). Signed-off-by: Andrej Picej <andrej.picej@xxxxxxxxx> --- - rather than deleting the dr_mode property, set the property to "otg" to explicitly set the mode to OTG --- arch/arm/dts/imx6qdl-phytec-pbab01.dtsi | 4 ++++ 1 file changed, 4 insertions(+) diff --git a/arch/arm/dts/imx6qdl-phytec-pbab01.dtsi b/arch/arm/dts/imx6qdl-phytec-pbab01.dtsi index 991c7e4fab..88db962535 100644 --- a/arch/arm/dts/imx6qdl-phytec-pbab01.dtsi +++ b/arch/arm/dts/imx6qdl-phytec-pbab01.dtsi @@ -15,6 +15,10 @@ status = "okay"; }; +&usbotg { + dr_mode = "otg"; +}; + #ifdef USE_STATE_EXAMPLE #include "state-example.dtsi" #endif -- 2.25.1 _______________________________________________ barebox mailing list barebox@xxxxxxxxxxxxxxxxxxx http://lists.infradead.org/mailman/listinfo/barebox