2017-04-04 9:22 GMT+03:00 Sascha Hauer <s.hauer@xxxxxxxxxxxxxx>: > On Mon, Apr 03, 2017 at 11:59:50PM +0300, Çağlar Kilimci wrote: >> Hello, >> >> Finally, I updated and patched the code and now I can see state@0 >> device in the of_dump: > > Ok, looks good. How does the boot log look like? Still the same? I think so. Here it is: barebox 2017.03.0-00129-g444ee36 #1 Mon Apr 3 10:28:04 +03 2017 Board: Phytec phyCORE AM335x omap-hsmmc 48060000.mmc: registered as 48060000.mmc booting from MMC mmc0: detected SD card version 2.0 mmc0: registered mmc0 barebox 2017.03.0-00153-g880fa12-dirty #3 Mon Apr 3 23:14:34 +03 2017 Board: Phytec phyCORE AM335x cpsw 4a100000.ethernet: detected phy mask 0x3 mdio_bus: miibus0: probed eth0: got preset MAC address: a0:f6:fd:6c:0d:b0 am335x-phy-driver 47401b00.usb-phy: am_usbphy 87f71cdc enabled musb-hdrc: ConfigData=0xde (UTMI-8, dyn FIFOs, bulk combine, bulk split, HB-ISO Rx, HB-ISO Tx, SoftConn) musb-hdrc: MHDRC RTL version 2.0 musb-hdrc: setup fifo_mode 4 musb-hdrc: 28/31 max ep, 16384/16384 memory m25p80 m25p80@00: unrecognized JEDEC id bytes: 00, 0, 0 m25p80 m25p80@00: probe failed: No such file or directory i2c-omap 44e0b000.i2c: bus 0 rev0.11 at 400 kHz omap-hsmmc 48060000.mmc: registered as 48060000.mmc mmc0: detected SD card version 2.0 mmc0: registered mmc0 omap_wdt 44e35000.wdt: OMAP Watchdog Timer Rev 0x01 nand: ONFI flash detected nand: NAND device: Manufacturer ID: 0x2c, Chip ID: 0xf1 (Micron MT29F1G08ABADAH4), 128MiB, page size: 2048, OOB size: 64 netconsole: registered as netconsole-1 malloc space: 0x87efef60 -> 0x8fdfdebf (size 127 MiB) running /env/bin/init... eth0: 100Mbps full duplex link detected DHCP client bound to address 192.168.1.29 Hit m for menu or any other key to stop autoboot: 3 type exit to get to the menu barebox@Phytec phyCORE AM335x:/ -- Çağlar Kilimci _______________________________________________ barebox mailing list barebox@xxxxxxxxxxxxxxxxxxx http://lists.infradead.org/mailman/listinfo/barebox
