> > > > When booting from an SD-Card/NOR-Flash/USB would I then need > > to use at91bootstrap, or can I use only barebox? > > > > If I move forward with this and I can find an 9263 > > evaluation kit I would then also update this. > On 9263 the sram is huge so you can build barebox as first stage Good - simplicity is good. > > I add this a long time ago on usb_a9263_bootstrap_defconfig > or other (all the EK). > > This will build a barebox that can load you image from multiple source in a sequence > > and then use a std barebox > > To switch to DT you will have to import the DT I did for the kernel OK, should be straighforward. > and replace the hw i2c by a i2c gpio as the i2c IP on at91 has a lot of quirks > and for barebox it will not make sense to port it Seems less straightforward but doable. I will see if I can find time to give it a try and then post patches. Sam _______________________________________________ barebox mailing list barebox@xxxxxxxxxxxxxxxxxxx http://lists.infradead.org/mailman/listinfo/barebox
