Based on kernel commit 00aee095000c ("net: phy: micrel: use BIT macro")
by Johan Hovold <johan@xxxxxxxxxx>.
Signed-off-by: Philipp Zabel <p.zabel@xxxxxxxxxxxxxx>
---
drivers/net/phy/micrel.c | 18 +++++++++---------
1 file changed, 9 insertions(+), 9 deletions(-)
diff --git a/drivers/net/phy/micrel.c b/drivers/net/phy/micrel.c
index 2f31906..0c97e25 100644
--- a/drivers/net/phy/micrel.c
+++ b/drivers/net/phy/micrel.c
@@ -25,17 +25,17 @@
/* Operation Mode Strap Override */
#define MII_KSZPHY_OMSO 0x16
-#define KSZPHY_OMSO_B_CAST_OFF (1 << 9)
-#define KSZPHY_OMSO_RMII_OVERRIDE (1 << 1)
-#define KSZPHY_OMSO_MII_OVERRIDE (1 << 0)
+#define KSZPHY_OMSO_B_CAST_OFF BIT(9)
+#define KSZPHY_OMSO_RMII_OVERRIDE BIT(1)
+#define KSZPHY_OMSO_MII_OVERRIDE BIT(0)
/* general PHY control reg in vendor specific block. */
#define MII_KSZPHY_CTRL 0x1F
/* bitmap of PHY register to set interrupt mode */
-#define KSZPHY_CTRL_INT_ACTIVE_HIGH (1 << 9)
-#define KSZ9021_CTRL_INT_ACTIVE_HIGH (1 << 14)
-#define KS8737_CTRL_INT_ACTIVE_HIGH (1 << 14)
-#define KSZ8051_RMII_50MHZ_CLK (1 << 7)
+#define KSZPHY_CTRL_INT_ACTIVE_HIGH BIT(9)
+#define KSZ9021_CTRL_INT_ACTIVE_HIGH BIT(14)
+#define KS8737_CTRL_INT_ACTIVE_HIGH BIT(14)
+#define KSZ8051_RMII_50MHZ_CLK BIT(7)
/* Write/read to/from extended registers */
#define MII_KSZPHY_EXTREG 0x0b
@@ -231,8 +231,8 @@ static int ksz9031_config_init(struct phy_device *phydev)
}
#define KSZ8873MLL_GLOBAL_CONTROL_4 0x06
-#define KSZ8873MLL_GLOBAL_CONTROL_4_DUPLEX (1 << 6)
-#define KSZ8873MLL_GLOBAL_CONTROL_4_SPEED (1 << 4)
+#define KSZ8873MLL_GLOBAL_CONTROL_4_DUPLEX BIT(6)
+#define KSZ8873MLL_GLOBAL_CONTROL_4_SPEED BIT(4)
static int ksz8873mll_read_status(struct phy_device *phydev)
{
int regval;
--
2.7.0.rc3
_______________________________________________
barebox mailing list
barebox@xxxxxxxxxxxxxxxxxxx
http://lists.infradead.org/mailman/listinfo/barebox
