Based on kernel commit d2fd719bcb0e ("net/phy: micrel: Add workaround for bad autoneg") by Nathan Sullivan <nathan.sullivan@xxxxxx>: Very rarely, the KSZ9031 will appear to complete autonegotiation, but will drop all traffic afterwards. When this happens, the idle error count will read 0xFF after autonegotiation completes. Reset the PHY when in that state. Signed-off-by: Philipp Zabel <p.zabel@xxxxxxxxxxxxxx> --- drivers/net/phy/micrel.c | 23 ++++++++++++++++++++++- 1 file changed, 22 insertions(+), 1 deletion(-) diff --git a/drivers/net/phy/micrel.c b/drivers/net/phy/micrel.c index 570272f..e8a566d 100644 --- a/drivers/net/phy/micrel.c +++ b/drivers/net/phy/micrel.c @@ -273,6 +273,27 @@ static int ksz8873mll_read_status(struct phy_device *phydev) return 0; } +static int ksz9031_read_status(struct phy_device *phydev) +{ + int err; + int regval; + + err = genphy_read_status(phydev); + if (err) + return err; + + /* Make sure the PHY is not broken. Read idle error count, + * and reset the PHY if it is maxed out. + */ + regval = phy_read(phydev, MII_STAT1000); + if ((regval & 0xff) == 0xff) { + phy_init_hw(phydev); + phydev->link = 0; + } + + return 0; +} + static int ksz8873mll_config_aneg(struct phy_device *phydev) { return 0; @@ -368,7 +389,7 @@ static struct phy_driver ksphy_driver[] = { .features = (PHY_GBIT_FEATURES | SUPPORTED_Pause), .config_init = ksz9031_config_init, .config_aneg = genphy_config_aneg, - .read_status = genphy_read_status, + .read_status = ksz9031_read_status, }, { .phy_id = PHY_ID_KSZ8873MLL, .phy_id_mask = 0x00fffff0, -- 2.7.0.rc3 _______________________________________________ barebox mailing list barebox@xxxxxxxxxxxxxxxxxxx http://lists.infradead.org/mailman/listinfo/barebox