Hi ... I'm using barebox 2014.02.0 to boot with a clone of the mini2440
board using the MT29F8G08ABABAWP NAND.
I'm getting the following error:
barebox 2014.02.0 #1 Thu Mar 13 15:28:57 CDT 2014
Board: <NULL>
nand: ONFI param page 0 valid
nand: ONFI flash detected
nand: NAND device: Manufacturer ID: 0x2c, Chip ID: 0x38 (Micron
MT29F8G08ABABAWP), 1024
nand: No oob scheme defined for oobsize 224
BUG: failure at drivers/mtd/nand/nand_base.c:3357/nand_scan_tail()!
BUG!
no stack data available
DIVN_UPLL0
MPLLVal [M:61h,P:1h,S:2h]
CLKDIVN:7h
After this poing the board gets resetted back to the original point. I
can never get to the barebox prompt.
Any ideas on how to fix this ??
Thanks in advance ...
_______________________________________________
barebox mailing list
barebox@xxxxxxxxxxxxxxxxxxx
http://lists.infradead.org/mailman/listinfo/barebox
