Hi, Le Thu, 13 Mar 2014 15:32:23 -0400, raespi <raespi@xxxxxxx> a écrit : > Hi ... I'm using barebox 2014.02.0 to boot with a clone of the mini2440 > board using the MT29F8G08ABABAWP NAND. > > I'm getting the following error: > > barebox 2014.02.0 #1 Thu Mar 13 15:28:57 CDT 2014 > > Board: <NULL> > nand: ONFI param page 0 valid > nand: ONFI flash detected > nand: NAND device: Manufacturer ID: 0x2c, Chip ID: 0x38 (Micron > MT29F8G08ABABAWP), 1024 > nand: No oob scheme defined for oobsize 224 > BUG: failure at drivers/mtd/nand/nand_base.c:3357/nand_scan_tail()! > BUG! > no stack data available > DIVN_UPLL0 > MPLLVal [M:61h,P:1h,S:2h] > CLKDIVN:7h > > After this poing the board gets resetted back to the original point. I > can never get to the barebox prompt. > > Any ideas on how to fix this ?? > you may need to add support for 4k+224 page size to your nand controller. For example this was done for i.MX in comit 632c45795065e6a7471ab82be38e808eb6204341 Eric _______________________________________________ barebox mailing list barebox@xxxxxxxxxxxxxxxxxxx http://lists.infradead.org/mailman/listinfo/barebox
