On Tue, 10 Dec 2013 14:31:23 +0100 Atilla Filiz <atilla.filiz@xxxxxxxxx> wrote: > Ok, then my problem is slightly more clear, that /dev/phy0 does not exist. > I do define a struct fec_platform_data with > xcv_type=PHY_INTERFACE_MODE_MII and register it via imx27_add_fec(). > > Now I need to find out why it fails to register the device. There is an issue with current barebox. The /dev/phy0 device not present just after boot. You need somehow to use network to make it appeared. Use this [ugly!] method: Run barebox on your board. Just after boot /dev/phy0 is absent. So run 'dhcp' command. In a few seconds press "ctrl-c" to interrupt it. Check /dev/phy0 presence. > On Fri, Dec 6, 2013 at 1:43 PM, Alexander Aring <alex.aring@xxxxxxxxx> wrote: > > On Fri, Dec 06, 2013 at 01:39:25PM +0100, Sascha Hauer wrote: > >> On Fri, Dec 06, 2013 at 01:18:52PM +0100, Atilla Filiz wrote: > >> > Sorry, figured it out. Just most verbose output is funny as well: > >> > :/ miitool -vvv /dev/mc13xxx > >> > >> Don't know what miitool does in this case, but mc13xxx is not your phy, > >> it's your PMIC. > >> > > > > oh, doesn't realize that :D. So reading zeros can make sense in some > > offset. :-) > > > > - Alex > > > > -- > Atilla Filiz > > _______________________________________________ > barebox mailing list > barebox@xxxxxxxxxxxxxxxxxxx > http://lists.infradead.org/mailman/listinfo/barebox -- -- Best regards, Antony Pavlov _______________________________________________ barebox mailing list barebox@xxxxxxxxxxxxxxxxxxx http://lists.infradead.org/mailman/listinfo/barebox
