One small issue I am facing: The board has a jumper to switch between 'internal boot' and 'serial boot'. If I set it to 'serial boot' and then use imx-usb-loader to load barebox to RAM, everything works just fine. When I then try to flash it (flash controller support is missing in this patch-set), flashing is successful, however I am not able to boot it later when switched to 'internal boot' mode. If I try to flash some old version of the barebox (from my version running in RAM -- thus the problem is probably not in the flash support), it not only flashes successfully, this older version is even able to boot in the 'internal boot' mode. I also noticed that when I am using CONFIG_IMX_MULTI_BOARDS the whole set of CONFIG_ARCH_IMX_INTERNAL_BOOT_* disappears. Commands I am using to flash barebox: erase /dev/nand0 addpart /dev/nand0 512k(barebox)ro,512k(bareboxenv),4M(kernel),-(rootfs) nand -a /dev/nand0.* erase /dev/nand0.barebox.bb tftp /vmx53/barebox.bin /dev/nand0.barebox.bb Thanks in advance for any suggestions. Rostislav On Tue, 2013-11-12 at 23:46 +0100, Rostislav Lisovy wrote: > This patchset adds support for Voipac Baseboard using x53-dmm-668 > module (equipped with i.mx53 CPU). More info about the module may > be found at: http://www.voipac.com/#X53-DMM-668 > > Changes since v1: > * Fixed error checking in fec_imx.c > * Board support is now done in the 'multiboard way' > > Rostislav Lisovy (3): > ARM: dts: i.mx53: Internal keyboard controller + i2c pinmux > ARM: i.mx53: Parse Reset GPIO pin in FEC driver from Devicetree > ARM: i.mx53: Support for Voipac board with X53-DMM-668 module. > > arch/arm/boards/Makefile | 1 + > arch/arm/boards/freescale-mx53-vmx53/Makefile | 3 + > arch/arm/boards/freescale-mx53-vmx53/board.c | 42 +++++ > .../boards/freescale-mx53-vmx53/env/config-board | 8 + > .../flash-header-imx53-vmx53.imxcfg | 54 ++++++ > arch/arm/boards/freescale-mx53-vmx53/lowlevel.c | 19 ++ > arch/arm/dts/Makefile | 4 +- > arch/arm/dts/imx53-voipac-bsb.dts | 135 ++++++++++++++ > arch/arm/dts/imx53-voipac-dmm-668.dtsi | 196 ++++++++++++++++++++ > arch/arm/dts/imx53.dtsi | 15 ++ > arch/arm/mach-imx/Kconfig | 8 + > drivers/net/fec_imx.c | 33 ++++ > images/Makefile.imx | 5 + > 13 files changed, 522 insertions(+), 1 deletion(-) > create mode 100644 arch/arm/boards/freescale-mx53-vmx53/Makefile > create mode 100644 arch/arm/boards/freescale-mx53-vmx53/board.c > create mode 100644 arch/arm/boards/freescale-mx53-vmx53/env/config-board > create mode 100644 arch/arm/boards/freescale-mx53-vmx53/flash-header-imx53-vmx53.imxcfg > create mode 100644 arch/arm/boards/freescale-mx53-vmx53/lowlevel.c > create mode 100644 arch/arm/dts/imx53-voipac-bsb.dts > create mode 100644 arch/arm/dts/imx53-voipac-dmm-668.dtsi > _______________________________________________ barebox mailing list barebox@xxxxxxxxxxxxxxxxxxx http://lists.infradead.org/mailman/listinfo/barebox
